Fuel Tank Cap and Strainer - Clean - If Equipped
要想使发动机保持最佳状态,应避免燃油遭受污染。 由于燃油系统污染通常发生在重新加注过程中,因此应遵循以下几点:
- 只使用可靠供应源的正确粘度级干净燃油。
- 不要从污染的容器或不适合贮存燃油的容器加注燃油。
- 不要使用污染的设备。
- 定期清洁燃油加注口盖及其周围区域。
Show/hide table
图 1 | g02418637 |
燃油箱盖 (1) 位于机器的右侧,如图 1 中所示。
- 拆下燃油箱盖 (1) 和滤网 (2)。
- 密封好油箱口,以防止污染。
Show/hide table
图 3 g02418697 - 拆解燃油箱盖。 拆下燃油箱盖上的滤清器滤芯 (3) 和 (4)。
- 清洗箱盖和滤网。 在清洁的不易燃溶剂中清洗这些部件。
- 将新滤清器滤芯 (3) 和 (4) 安装到燃油箱盖上。
- 检查燃油箱盖的密封件。 如果密封件损坏,则更换密封件。
- 在箱盖部件上涂敷薄薄的一层油。
- 安装滤网。
- 安装燃油箱盖。
Show/hide table
图 2 | g02026955 |
Caterpillar Information System:
953D Track-Type Loader with Shiphold Arrangement Fuel Tank Water and Sediment - Drain - If Equipped
CG137-08 and CG137-12 Industrial Engines Engine Oil Pressure - Test
D8T and D9T Track-Type Tractors MID 113 - CID 0673 - FMI 02
CG137-08 and CG137-12 Industrial Engines Compression - Test
D8T and D9T Track-Type Tractors MID 082 - CID 1952 - FMI 09
D8T and D9T Track-Type Tractors MID 082 - CID 1952 - FMI 02
Installation of Cat® Detect Object Detection System for the 980H and 980K Wheel Loaders {1408, 7348} Installation of Cat® Detect Object Detection System for the 980H and 980K Wheel Loaders {1408, 7348}
Disassembly and Assembly Procedures for Track Rollers with Inverted Duo-Cone Seals {0599, 0729, 4180, 4180, 7555, 7561} Disassembly and Assembly Procedures for Track Rollers with Inverted Duo-Cone Seals {0599, 0729, 4180, 4180, 7555, 7561}
D7E Track-Type Tractor Hydraulic, HVAC and Electrical Systems Air Conditioner
Procedure to Retrofit A Comfort Series Seat to Certain Underground Articulated Trucks{7312, 7324} Procedure to Retrofit A Comfort Series Seat to Certain Underground Articulated Trucks{7312, 7324}
2011/04/08 Improvements To the Rear Panel On 973D Track-Type Loaders {7251, 7256}
Instructions to Install Connector Lock Wire on D7E Track-Type Tractors{1408, 7553} Instructions to Install Connector Lock Wire on D7E Track-Type Tractors{1408, 7553}
C4.4 Industrial Engine Burn Prevention
D7E Track-Type Tractor Hydraulic, HVAC and Electrical Systems Push Arm
980K Wheel Loader Electrohydraulic System MID 082 - CID 0350 - FMI 03
980K Wheel Loader C13 Engine Supplement Hood Tilt Pump and Motor - Remove and Install
D6N Track-Type Tractor Leaving the Machine
966M Tier 4, 966M Tier 4 Series XE, 972M Tier 4 and 972M Tier 4 Series XE Wheel Loaders Blower Motor (Air Conditioner and Heater) - Remove and Install
980K Wheel Loader Electrohydraulic System MID 082 - CID 0350 - FMI 04
980K Wheel Loader Electrohydraulic System MID 082 - CID 0350 - FMI 08
980K Wheel Loader Electrohydraulic System MID 082 - CID 0350 - FMI 13
980K Wheel Loader Electrohydraulic System MID 082 - CID 0351 - FMI 03
994H Wheel Loader Power Train Output Transfer Gears - Remove
994H Wheel Loader Power Train Output Transfer Gears - Install