Compression - Test
Show/hide table
所需工具     | ||
---|---|---|
零件号     | 说明     | 数量     |
193-5859     | 气缸压力表总成 (燃气发动机)     | 1     |
气缸压力可在检查火花塞测量。 可通过检查气缸压力测试下列各项的状况:气门, 气门座圈, 活塞, 活塞环 和 缸套。
一个或多个气缸的压力下降或变化可能表示下列状况。 这些状况可能表示存在润滑故障:
- 积碳过多
- 气门故障或断裂
- 活塞环卡滞或断裂
- 活塞环磨损
- 缸套磨损
约 250 工作小时后,测量发动机气缸压力。 记录该数据。 连续定期测量气缸压力。 将记录的数据与新的数据相比较可提供有关发动机状况的信息。
注: 气缸压力是帮助确定大修周期的考虑因素之一。 有关详细信息,请参阅您发动机的操作和保养手册。
如果气缸压力提高是由于一个或多个气缸压缩比的原因,发动机需要进行上部大修,以清除积碳。 不清除沉积物,会增加爆震的机会。 将会产生严重的气门沟槽。
使用 193-5859 气缸压力表总成 (燃气发动机)来测量气缸压力。 使用仪表所带的专门说明书, NEHS0798。 按照下列指南进行:
- 拆下全部火花塞。
- 完全打开油门板。
- 尽可能缩短起动时间。 此策略将使检查时的连续起动速度达到最大。 另外,也能节省蓄电池的电力。
图 1 是具有不同压缩比的发动机的气缸压力近似图。 参考此图。
Show/hide table
图 1 | g02417877 |
燃气发动机气缸压力近似图 |
Caterpillar Information System:
D8T and D9T Track-Type Tractors MID 082 - CID 1952 - FMI 09
D8T and D9T Track-Type Tractors MID 082 - CID 1952 - FMI 02
Installation of Cat® Detect Object Detection System for the 980H and 980K Wheel Loaders {1408, 7348} Installation of Cat® Detect Object Detection System for the 980H and 980K Wheel Loaders {1408, 7348}
Disassembly and Assembly Procedures for Track Rollers with Inverted Duo-Cone Seals {0599, 0729, 4180, 4180, 7555, 7561} Disassembly and Assembly Procedures for Track Rollers with Inverted Duo-Cone Seals {0599, 0729, 4180, 4180, 7555, 7561}
D7E Track-Type Tractor Hydraulic, HVAC and Electrical Systems Air Conditioner
Procedure to Retrofit A Comfort Series Seat to Certain Underground Articulated Trucks{7312, 7324} Procedure to Retrofit A Comfort Series Seat to Certain Underground Articulated Trucks{7312, 7324}
2011/04/08 Improvements To the Rear Panel On 973D Track-Type Loaders {7251, 7256}
Instructions to Install Connector Lock Wire on D7E Track-Type Tractors{1408, 7553} Instructions to Install Connector Lock Wire on D7E Track-Type Tractors{1408, 7553}
D6N Track-Type Tractor Equipment Lowering with Engine Stopped
D6N Track-Type Tractor Ripper Tips
966K Wheel Loader and 972K Wheel Loader Power train Modulating Valve (Transmission Clutch)
D6N Track-Type Tractor Window Wipers - Inspect/Replace
D8T and D9T Track-Type Tractors MID 113 - CID 0673 - FMI 02
CG137-08 and CG137-12 Industrial Engines Engine Oil Pressure - Test
953D Track-Type Loader with Shiphold Arrangement Fuel Tank Water and Sediment - Drain - If Equipped
953D Track-Type Loader with Shiphold Arrangement Fuel Tank Cap and Strainer - Clean - If Equipped
C4.4 Industrial Engine Burn Prevention
D7E Track-Type Tractor Hydraulic, HVAC and Electrical Systems Push Arm
980K Wheel Loader Electrohydraulic System MID 082 - CID 0350 - FMI 03
980K Wheel Loader C13 Engine Supplement Hood Tilt Pump and Motor - Remove and Install
D6N Track-Type Tractor Leaving the Machine
966M Tier 4, 966M Tier 4 Series XE, 972M Tier 4 and 972M Tier 4 Series XE Wheel Loaders Blower Motor (Air Conditioner and Heater) - Remove and Install
980K Wheel Loader Electrohydraulic System MID 082 - CID 0350 - FMI 04
980K Wheel Loader Electrohydraulic System MID 082 - CID 0350 - FMI 08