Inlet Air Temperature Sensor - Remove and Install
拆卸步骤
Show/hide table
| 注意 |
|---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 从进气温度传感器 (2) 上断开线束组件 (1) 。
Show/hide table
 | |
| 图 1 | g01260417 |
- 拆下进气温度传感器 (2) 。 从进气温度传感器 (2) 上拆下 O 形密封圈。
安装步骤
- 在进气温度传感器 (2) 上安装 O 形密封圈。
Show/hide table
| | |
| 图 2 | g01260417 |
注: 检查 O 形密封圈有无磨损或损坏。 如有必要，更换O型密封圈。
- 安装进气温度传感器 (2) 。 将进气温度传感器 (2) 上紧到 20 ± 5 N·m (15 ± 4 lb ft) 的扭矩。
- 在进气温度传感器 (2) 上连接线束组件 (1) 。
Caterpillar Information System:
C7 On-Highway Engine Cylinder Head - Install
UPS 120, UPS 150, UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies System Shutdown (MMS) - MMS System Shutdown
CX28 On-Highway Transmission Visual Inspection
CX28 On-Highway Transmission General Troubleshooting Information
UPS 120, UPS 150, UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies System Shutdown (SMS) - Single Module System
C15 On-Highway Engine Electronic Unit Injector Sleeve - Install
C15 On-Highway Engine Electronic Unit Injector Sleeve - Remove
C7 PETROLEUM Petroleum Engine Turbocharger Outlet Pressure Sensor - Remove and Install
C4.4 Industrial Engine Crankcase Breather (Canister) - Replace
C7 PETROLEUM Petroleum Engine Speed/Timing Sensor - Remove and Install
AccuGrade® GPS (CD700) Beeper
C7 PETROLEUM Petroleum Engine Injection Actuation Pressure Sensor - Remove and Install
CX28 On-Highway Transmission Torque Converter
C7 PETROLEUM Petroleum Engine Fan Drive - Remove
CX28 On-Highway Transmission Power Train Hydraulic System
AccuGrade® GPS (CD700) Brightness (Display and Light Bar)
CX28 On-Highway Transmission Transmission Planetary
C7 PETROLEUM Petroleum Engine Fan Drive - Disassemble
CX28 On-Highway Transmission Torque Converter
C4.4 Industrial Engine Fuel Injection Lines
C4.4 Industrial Engine Fuel Transfer Pump
C4.4 Industrial Engine Fuel Filter Base
C4.4 Industrial Engine Fuel Injection Pump
3456 Generator Sets Reference Material