Speed/Timing Sensor - Remove and Install
拆卸步骤
开始:
- 拆卸空气压缩机。 请参阅拆解和组装, "空气压缩机 - 拆卸和安装"。
- 从转速/正时传感器 (1) 上断开线束组件 (2) 。
Show/hide table
图 1 | g01175595 |
- 拆下螺栓 (3) 、垫圈 (4) 和支架 (5) 。 拆下转速/正时传感器 (1) 。 从转速/正时传感器 (1) 上拆下 O 形密封圈。
Show/hide table
图 2 | g01175674 |
安装步骤
Show/hide table
所需工具     | |||
工具     | 零件号     | 零件描述     | 数量     |
A     | 5P-3975     | 橡胶润滑剂     | 1     |
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 安装之前先在 O 形密封圈上涂抹工具 (A) 。 安装转速/正时传感器 (1) 。
Show/hide table
图 3 | g01175674 |
注: 检查 O 形密封圈有无磨损或损坏。 如有必要,更换O形密封圈。
- 定位支架 (5) 并安装螺栓 (3) 和垫圈 (4) 。 将螺栓 (3) 上紧到 28 ± 7 N·m (21 ± 5 lb ft) 的扭矩。
- 在转速/正时传感器 (1) 上连接线束组件 (2) 。
Show/hide table
图 4 | g01175595 |
End By: 安装空气压缩机。 请参阅 拆解和组装, "空气压缩机 - 拆卸和安装"。
Caterpillar Information System:
AccuGrade® GPS (CD700) Beeper
C7 PETROLEUM Petroleum Engine Injection Actuation Pressure Sensor - Remove and Install
2006/08/01 A New Piston Cooling Jet Assembly Has Been Released {1331}
AccuGrade® GPS (CD700) Avoidance Zone
2006/08/14 A New Piston Cooling Jet Assembly Has Been Released {1331}
2006/04/10 Clearly Mark all of the Cracks on the Cylinder Head Including Remanufactured Engines with Serial Number Prefixes 1WW, BFF, DLA, BFD, BKY, BLR, ECP, BGE, BKS, BLJ, B1A, BNF and 2MZ {1101, 7754}
C7 PETROLEUM Petroleum Engine Engine Oil Pressure Sensor - Remove and Install
CX31-P600 Petroleum Transmission Transmission Planetary
C7 On-Highway Engine Cylinder Head - Remove
C7 PETROLEUM Petroleum Engine Coolant Temperature Sensor - Remove and Install
AccuGrade® GPS (CD700) Setup Menu
CX31 On-Highway Transmission Modulating Valve (Torque Converter Lockup Clutch) - Test
C4.4 Industrial Engine Crankcase Breather (Canister) - Replace
C7 PETROLEUM Petroleum Engine Turbocharger Outlet Pressure Sensor - Remove and Install
C15 On-Highway Engine Electronic Unit Injector Sleeve - Remove
C15 On-Highway Engine Electronic Unit Injector Sleeve - Install
UPS 120, UPS 150, UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies System Shutdown (SMS) - Single Module System
CX28 On-Highway Transmission General Troubleshooting Information
CX28 On-Highway Transmission Visual Inspection
UPS 120, UPS 150, UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies System Shutdown (MMS) - MMS System Shutdown
C7 On-Highway Engine Cylinder Head - Install
C7 PETROLEUM Petroleum Engine Inlet Air Temperature Sensor - Remove and Install
CX28 On-Highway Transmission Torque Converter
C7 PETROLEUM Petroleum Engine Fan Drive - Remove