TS185 and TS225 Towed Scrapers Machine Systems Caterpillar

Illustration 1	g01914738

Procedure for Adjusting the Ejector Rollers

1. Park the pull unit on a level surface. Place the transmission direction control lever of the pull unit in the Neutral position, and engage the parking brake.

2. Lower all attachments to the ground and place chocks in front of the wheels and behind the wheels.

3. Loosen nut (1) .

4. Then turn shaft (2) until dimension (A) is 6.4 ± 1.5 mm (0.25 ± 0.06 inch).

5. Then tighten nut (1) to the proper torque.

6. Repeat this procedure for the other side.

Procedure for Adjusting the Slide that Contacts the Ejector and the Side Wall

Illustration 2	g01642934
View of the left side of the ejector

(1) The minimum allowable width for dimension (B) is 51 mm (2 inches).

Procedure for Adjusting the Slides on the Rear Ejector Frame

Illustration 3	g01814015
View of the slides for the ejector

(2) The minimum allowable thickness for dimension (C) is 66.68 mm (2.625 inch). The minimum allowable thickness for the dimension (D) is 38 mm (1.5 inch).