- Track-Type Tractor:
- D8T (S/N: J8B1-UP; KPZ1-UP)
A more reliable toggle switch is available for use as an actuator for the fuel priming pump.
The 158-6632 Push Button Switch Gp is used in the following locations on the D8T Track-type Tractor:
- The switch is used in the operator station as a push button for the horn.
- The switch is used in the engine compartment as an actuator for the fuel priming pump.
For use as an actuator for the fuel priming pump, replace the 158-6632 Push Button Switch Gp with the 207-6941 Toggle Switch .
Required Parts
Table 1 lists the former parts, the new parts, and the additional parts that are used in order to replace the 158-6632 Push Button Switch Gp.
Former Parts and New Parts     | |||
Former Part     | New Part     | ||
158-6632 Push Button Switch Gp     | 207-6941 Toggle Switch     | ||
236-7649 Plate     | 305-3684 Identification Plate     | ||
191-1783 Spacer     | 232-1376 Spacer     | ||
8H-8769 Bolt     | 4F-3508 Bolt     | ||
N/A     | 232-1374 Bracket     | ||
Additional Parts     | |||
158-6632 Push Button Switch Gp     | 207-6941 Toggle Switch     | ||
Part Number     | Qty     | Part Number     | Qty     |
8T-9655 Isolation Mount     | 4     | 8T-9655 Isolation Mount     | 6     |
Replace the Push Button Switch
Illustration 1 | g01580615 |
Left side view (1) 1D-4538 Bolt (2) 236-7649 Plate (3) 158-6632 Push Button Switch Gp (4) 8H-8769 Bolts (5) 191-1783 Spacers |
- Disconnect the harness connector for the fuel priming pump.
- Remove bolt (1) from the top of the filter base.
- Discard plate (2) and switch (3) .
- Remove bolts (4) and spacers (5) from the bottom of the filter base. Discard bolts (4) and spacers (5) .
- Reinstall bolt (1) at the top of the fuel filter base.
- Install spacers (6), bracket (9) and isolation mounts (10). Fasten bracket (9) to the fuel filter base with bolts (11) and washers (8) .
Illustration 2 | g01580895 |
Fuel filter base (6) 232-1376 Spacers (7) 207-6941 Toggle Switch (8) 9N-0869 Hard Washers (9) 232-1374 Bracket (10) 8T-9655 Isolation Mounts (11) 4F-3508 Bolts |
- Mount switch (7) and identification plate (15) to bracket (9). Use two nuts (12), one lockwasher (13), and one locking ring (14) in order to fasten the switch to the bracket.
Torque ... 2.2 ± 0.1 N·m (20 ± 1 lb in)
Illustration 3 | g01578634 |
207-6941 Toggle Switch (12) 6T-3631 Hex Nuts (13) 6T-3632 Lockwasher (14) 6T-3633 Locking Ring (15) 305-3684 Identification Plate |
- Connect the two-pin connector to the engine harness.
Illustration 4 | g01581074 |
New switch |