Engine Oil Pan
Show/hide table
 | |
| Illustration 1 | g01255447 |
Note: The sealing surfaces of the oil pan shall be free of oil, debris, gasket material that is protruding, or any other sealant. The oil pan must be assembled and tightened to the cylinder block within ten minutes of applying sealant.
Apply 4C-9612 Silicone Sealant to a bead of 5 mm (0.2 inch) at four areas on the sealing surface of the oil pan. The areas are marked location (1) . The areas are at the corners of the oil pan in the following locations:
- Connecting joint of the front housing and the front of the cylinder block
- Connecting joint of the flywheel housing and the rear of the cylinder block
Caterpillar Information System:
3176C and 3196 Marine Engines Safety Messages
2006/03/20 A New Valve Bridge May Need to Be Installed on Certain Engines {1100}
CX31 On-Highway Transmission Retarder Troubleshooting
3176C and 3196 Marine Engines Declaration of Conformity
C11 and C13 Petroleum Engines Alternator and Regulator
2006/04/10 New Oil Pan Groups Have Been Released {1302}
C7 PETROLEUM Petroleum Engine Fuel Filter Base - Remove and Install
G3508, G3512 and G3516 Engines Drive Housing (Front) - Remove and Install
C7 PETROLEUM Petroleum Engine Fuel Priming Pump - Remove and Install
G3500 A3 Engines Actuator Linkage - Air/Fuel Ratio Valve
C3.3 and C4.4 Generator Sets Generator - Install
C3.3 and C4.4 Generator Sets Generator - Remove
C9 Industrial Engines Alternator and Regulator
2006/03/01 A New Valve Bridge May Need to Be Installed on Certain Engines {1100}
C7 On-highway Engine Engine Oil Pan
C-15, C-16, and C-18 Truck Engines Alternator and Regulator
3116 and 3126 Marine Engines Declaration of Conformity
3126B Marine Engine Safety Messages
C15 On-Highway Engine Coolant Temperature Sensor - Remove and Install
C15 On-Highway Engine Engine Oil Pressure Sensor - Remove and Install
C15 On-Highway Engine Belt Tensioner - Remove and Install
2006/04/03 A New Grease is Used {0645}
Turbocharger Surge on G3500 Generator Sets and G3500 Generator Set Engines that are Equipped with Dual Turbochargers{1052, 1057, 1071} Turbocharger Surge on G3500 Generator Sets and G3500 Generator Set Engines that are Equipped with Dual Turbochargers{1052, 1057, 1071}
TH31-C9I, TH31-C9P, TH31-C9T, TH35-C11I, TH35-C13I, TH35-C13T, TH35-C15I and TH35-C15T Petroleum Power Train Packages and TH31-E61 and TH35-E81 Petroleum Transmissions Power Train Electronic Control System MID 027 - CID 0177 - FMI 00