Start By:
- Release the hydraulic system pressure. Refer to Disassembly and Assembly , " Hydraulic System Pressure - Release".
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
NOTICE |
---|
Keep all parts clean from contaminants. Contamination of the hydraulic system with foreign material will reduce the service life of the hydraulic system components. To prevent contaminants from entering the hydraulic system, always plug or cap the lines, fittings, or hoses as they are disconnected. Cover any disassembled components and clean them properly before assembly. Clean the hydraulic system properly after any major component exchange or especially after a component failure, to remove any contamination. |
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
- Remove lever (2). Remove knobs (4) and armrest (1). Remove bolts (5) and (6). Remove covers (3) and (7).
Show/hide table
Illustration 2 g01443051 - Remove bolts (8) and position bracket (9) to the side.
Show/hide table
Illustration 3 g01443054 - Remove knob (12). Remove bolts (11) and (13). remove panels (10) and (14).
Show/hide table
Illustration 4 g01443055 - Remove bolts (15) and cover (16). Remove bolts (18) and cover (17).
Show/hide table
Illustration 5 g01443056 - Remove screws (19) and place lever (20) to the side.
Show/hide table
Illustration 6 g01443057 - Remove bolts (21) and (23). Remove bracket (22).
Show/hide table
Illustration 7 g01443058 - Remove screws (24) and (25).
Show/hide table
Illustration 8 g01443059 - Cut cable straps (28) and (31). Disconnect harness assembly (30). Remove bolts (26) and (29). Remove bracket (27).
Show/hide table
Illustration 9 g01443060 - Disconnect hose assemblies (32) and (33).
Show/hide table
Illustration 10 g01443062 - Disconnect harness assembly (36). Disconnect hose assemblies (37) and (38). Remove bolts (35) and remove STIC control (34).
Illustration 1 | g01443048 |