Fuel Control Actuator - Remove and Install
Removal Procedure
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Disconnect the harness assembly from fuel control actuator (2) .
Show/hide table
 | |
| Illustration 1 | g01249234 |
- Remove bolt (3) and disconnect linkage (4) from fuel control actuator (2) .
- Remove bolts (1) from fuel control actuator (2) .
- Remove fuel control actuator (2) from the mounting plate.
Installation Procedure
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Position fuel control actuator (2) on the mounting plate.
Show/hide table
| | |
| Illustration 2 | g01249234 |
- Install bolts (1) in fuel control actuator (2) .
- Place linkage (4) on fuel control actuator (2) and install bolt (3) .
Note: Ensure that proper orientation is maintained during installation of linkage (4) .
- Connect the harness assembly to fuel control actuator (2) .
Caterpillar Information System:
C4.4 Industrial Engine Safety Messages
G3406 Engine Engine Air Precleaner - Check/Clean
3406C Engines for Caterpillar Built Machines Engine Oil Pan
Caterpillar On-Highway Diesel Engine Fluids Recommendations Extended Life Coolant Cooling System Maintenance
C280 Marine Propulsion Engines Panel Relay
AccuGrade® GPS (CD700) Wiring Harness (Short Circuit) - Test
AccuGrade® GPS (CD700) Wiring Harness (Open Circuit) - Test
C280 Marine Propulsion Engines Throttle Position Sensor - Calibrate
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines CID 0004 FMI 06
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines CID 0003 FMI 06
AccuGrade® GPS (CD700) Angle Sensor - Calibrate - AS300 System
C280 Marine Propulsion Engines Load Feedback - Calibrate
G3508, G3512 and G3516 Engines Fuel Control Actuator - Remove and Install
C280 Marine Propulsion Engines Throttle Position Sensor
G3508, G3512 and G3516 Engines Fuel Control Valve - Remove and Install
AccuGrade® GPS (CD700) Glossary of Terms
AccuGrade® GPS (CD700) General Information
AccuGrade® GPS (CD700) Service Tools
AccuGrade® GPS (CD700) Diagnostic Capabilities
G3508, G3512 and G3516 Engines Fuel Control Valve - Remove and Install - Low Pressure
C4.4 Industrial Engine Model View Illustrations
C9 Urban Transit Bus Engine Maintenance Interval Schedule
C4.4 Industrial Engine Engine Description
G3500 A3 Engines Gas Engine Ignition