Engine Oil Pan
Show/hide table
| |
| 图 1 | g02724361 |
Show/hide table
| 7W-0158 油底壳总成技术规格 | |||
| 项目 | 数量 | 零件 | 技术规格说明 |
| 1 | 1 | 4P-0519 排放接头 | 拧紧至扭矩为 |
| 2 | 1 | 319-6234 螺塞组件 | 拧紧至扭矩为 |
Show/hide table
| |
| 图 2 | g02634936 |
Show/hide table
| 7W-0158 油底壳总成技术规格 | |||
| 项目 | 数量 | 零件 | 技术规格说明 |
| - | - | - | 组装发动机油底壳期间使用以下步骤： |
| - | - | - | 油底壳的密封表面应没有机油、碎屑、密封垫材料或任何其他密封胶。 |
| - | - | - | 油底壳必须在涂抹密封胶的 10 分钟内组装并紧固至缸体。 |
| - | - | - | 1. 将 前壳体和缸体前部的连接点。 飞轮壳和缸体后部的连接点。 将一道密封胶涂覆到密封垫或壳体表面。 在 T 形接头位置，胶条应覆盖整个跨度。 |
| 3 | 39 | 3B-1915 螺栓 | 2. 将螺栓 1 至螺栓 40 按图 2 中所示的数字顺序拧紧至 |
| 3. 将螺栓 1 至螺栓 40 按图 2 中所示的数字顺序再次拧紧至 |
|||
Caterpillar Information System:
Caterpillar On-Highway Diesel Engine Fluids Recommendations Extended Life Coolant Cooling System Maintenance
C280 Marine Propulsion Engines Panel Relay
AccuGrade® GPS (CD700) Wiring Harness (Short Circuit) - Test
AccuGrade® GPS (CD700) Wiring Harness (Open Circuit) - Test
C280 Marine Propulsion Engines Throttle Position Sensor - Calibrate
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines CID 0004 FMI 06
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines CID 0003 FMI 06
AccuGrade® GPS (CD700) Angle Sensor - Calibrate - AS300 System
C280 Marine Propulsion Engines Load Feedback - Calibrate
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines CID 0002 FMI 06
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines CID 0004 FMI 05
C280 Marine Propulsion Engines Sensor Supply
G3406 Engine Engine Air Precleaner - Check/Clean
C4.4 Industrial Engine Safety Messages
G3508, G3512 and G3516 Engines Fuel Control Actuator - Remove and Install
G3508, G3512 and G3516 Engines Fuel Control Actuator - Remove and Install
C280 Marine Propulsion Engines Throttle Position Sensor
G3508, G3512 and G3516 Engines Fuel Control Valve - Remove and Install
AccuGrade® GPS (CD700) Glossary of Terms
AccuGrade® GPS (CD700) General Information
AccuGrade® GPS (CD700) Service Tools
AccuGrade® GPS (CD700) Diagnostic Capabilities
G3508, G3512 and G3516 Engines Fuel Control Valve - Remove and Install - Low Pressure
C4.4 Industrial Engine Model View Illustrations