Magneto Drive
Show/hide table
Illustration 1 | g01238421 |
(1) Coupling
(2) Drive slot angle
-
With the flywheel at 25° BTC of the compression stroke for No. 1 cylinder, install coupling (1) so that the drive slot is at the following angle:
- Drive slot angle ... 20 ± 5°
(3) Shaft
- Shaft diameter ... 22.140 ± .013 mm (0.8717 ± 0.0005 inch)
(4) Gear
(5) Camshaft gear
(6) Bolt
-
Refer to Disassembly and Assembly for the installation procedure for the camshaft gear.
- Torque ... 360 N·m (265 lb ft)
- Rotation for bolts ... Tighten an additional 90 degrees minimum.
(7) Magneto drive gear
Caterpillar Information System:
C9 On-highway Engine Valve Mechanism Cover
3500 Engines Turbocharger - Install
C15 and C18 Generator Set Engines Water Pump - Remove
3500 Engines Turbocharger - Remove
C15 and C18 Generator Set Engines Engine Oil Pump - Install
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Transmission, SPN 177 - FMI 16
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Transmission, SPN 177 - FMI 4
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Transmission, SPN 177 - FMI 3
3500 Engines Excessive Black Smoke
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Transmission, SPN 190 - FMI 8
C15 and C18 Generator Set Engines Engine Oil Pump - Remove
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Diagnostic Trouble Code List
3500 Engines Aftercooler - Remove and Install
C280 Marine and Petroleum Engines Atmospheric Pressure Sensor
C15 and C18 Generator Set Engines Water Pump - Install
C15 and C18 Generator Set Engines Water Temperature Regulator - Remove and Install
3512B and 3516B Engines Air Inlet Manifold - Remove and Install
3512E Petroleum Engines Air Inlet Manifold - Remove and Install
C4.4 (Mech) Industrial Engine Cooling System Coolant Level - Check
C15 and C18 Generator Set Engines Flywheel - Remove
C3.3 Industrial Engine Engine Oil Cooler - Inspect
C15 and C18 Generator Set Engines Flywheel Housing - Remove and Install
2006/02/06 New Kits Are Available to Repair Cracks and Threads in Ductile Iron {0676, 0685}
C280 Marine and Petroleum Engines Boost Pressure Sensor