Fuel Injection Pump
Show/hide table
Illustration 1 | g00380017 |
(1) Tighten the bushing to the following torque. ... 163 ± 14 N·m (120 ± 10 lb ft)
(2) Oil outlet
(3) Oil inlet
Show/hide table
Illustration 2 | g00380018 |
Section A-A |
(4) The centerline of the timing pin hole is in the fuel injection pump housing.
Show/hide table
Illustration 3 | g00380019 |
(5) Tighten the valve assembly to the following torque. ... 70 ± 14 N·m (52 ± 10 lb ft)
(6) Lubricate the seal with the lubricant that is being sealed.
(7) 7L-8696 Spring that is for the oil bypass valve
- Length under test force ... 28.7 mm (1.13 inch)
- Test force ... 32.1 ± 1.8 N (7.22 ± .40 lb)
- Free length after test ... 34.8 ± 0.3 mm (1.37 ± .01 inch)
- Outside diameter ... 7.37 mm (.290 inch)
- Test force ... 32.1 ± 1.8 N (7.22 ± .40 lb)
Caterpillar Information System:
3412 Generator Set Engines Fuel Injection Pump
3412 Generator Set Engines Fuel Injection Pump
3412 Generator Set Engines Fuel Injection Pump
C32 Petroleum Engines Pistons and Connecting Rods - Assemble
C32 Petroleum Engines Engine Oil Pump - Assemble
C32 Marine Engines Engine Oil Pump - Disassemble
C32 Marine Engines Engine Oil Pump - Install
C32 Marine Engines Engine Oil Pump - Remove
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines Idle Validation Switch Circuit - Test
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines E2143 Low Engine Coolant Level
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines E172 High Air Filter Restriction
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines E232 High Fuel/Water Separator Water Level
C7 Engine for AP-1000D, AP-1055D, BG-2455D, and BG-260D Asphalt Pavers Engine Will Not Crank
TH48-E80 Oil/Gas Transmission Control Manifold - Remove
C15 Petroleum Generator Set Engines Fuel Filter Base
TH48-E80 Oil/Gas Transmission Control Manifold - Install
TH48-E80 Oil/Gas Transmission Control Manifold - Disassemble
TH48-E80 Oil/Gas Transmission Control Manifold - Assemble
C15 Petroleum Generator Set Engines Turbocharger
TH48-E80 Oil/Gas Transmission Speed Sensor (Transmission) - Remove
TH48-E80 Oil/Gas Transmission Speed Sensor (Transmission) - Install
C-12 Generator Set Engine Sensors and Electrical Connectors
TH48-E80 Oil/Gas Transmission Transfer Gears - Remove - Idler
TH48-E80 Oil/Gas Transmission Transfer Gears - Install - Idler