Engine Oil Pump - Remove
开始:
- 拆下发动机油底壳。 请参阅拆解和组装, "发动机油底壳 - 拆卸和安装"。
Show/hide table
| 注意 |
|---|
|
在检查、保养、测试、调整及维修产品时，请小心确保盛接油液。 在打开任何舱室或拆卸任何含有油液的部件前，请准备好盛接液体用的适当容器。 |
Show/hide table
| 注意 |
|---|
|
保持所有零件清洁无杂质。 杂质会造成快速磨损並縮短部件使用寿命。 |
- 将管组件 (4) 和 (5) 从发动机机油泵 (3) 上断开。
- 拆下螺栓 (1) 和垫圈 (2)。 拆卸发动机机油泵 (3)。
Show/hide table
| |
| 图 1 | g01195903 |
Caterpillar Information System:
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines Idle Validation Switch Circuit - Test
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines E2143 Low Engine Coolant Level
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines E172 High Air Filter Restriction
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines E232 High Fuel/Water Separator Water Level
TH48-E80 Oil/Gas Transmission Pump Drive - Install
TH48-E80 Oil/Gas Transmission Pump Drive - Assemble
TH48-E80 Oil/Gas Transmission Pump Drive - Disassemble
TH48-E80 Oil/Gas Transmission Pump Drive - Remove
C27 and C32 Generator Set Engines Water Pump - Assemble
C7 Urban Transit Bus Engines Cooling System Coolant Sample (Level 1) - Obtain
TH48-E80 Oil/Gas Transmission Relief Valve (Torque Converter Outlet) - Install
TH48-E80 Oil/Gas Transmission Relief Valve (Torque Converter Outlet) - Assemble
C32 Marine Engines Engine Oil Pump - Install
C32 Marine Engines Engine Oil Pump - Disassemble
C32 Petroleum Engines Engine Oil Pump - Assemble
C32 Petroleum Engines Pistons and Connecting Rods - Assemble
3412 Generator Set Engines Fuel Injection Pump
3412 Generator Set Engines Fuel Injection Pump
3412 Generator Set Engines Fuel Injection Pump
3412 Generator Set Engines Fuel Injection Pump
C7 Engine for AP-1000D, AP-1055D, BG-2455D, and BG-260D Asphalt Pavers Engine Will Not Crank
TH48-E80 Oil/Gas Transmission Control Manifold - Remove
C15 Petroleum Generator Set Engines Fuel Filter Base
TH48-E80 Oil/Gas Transmission Control Manifold - Install