Sensors and Electrical Connectors
Show/hide table
Illustration 1 | g01197662 |
Electronic system |
Show/hide table
Illustration 2 | g01197411 |
Component locations (1) J37/P37 Connector (2) Service tool connector (3) Fuel temperature sensor (4) Fuel pressure sensor (5) J300/P300 Injector harness connector (6) Atmospheric pressure sensor (7) Timing calibration probe connector (8) Primary engine speed/timing sensor (9) Secondary engine speed/timing sensor (10) Coolant temperature sensor (11) Engine oil pressure sensor (12) J2/P2 ECM connectors (13) ECM (14) J1/P1 ECM connectors (15) Inlet manifold air temperature sensor (16) Turbocharger outlet pressure sensor |
Show/hide table
Illustration 3 | g01184379 |
ECM and harness connectors |
Show/hide table
Illustration 4 | g01184547 |
J37/P37 Connector (40 pin) |
Show/hide table
Illustration 5 | g01184539 |
J300/P300 Injector harness |
Show/hide table
Illustration 6 | g01158896 |
Service tool connector |
Show/hide table
Illustration 7 | g01159881 |
3 wire sensor connector |
Show/hide table
Illustration 8 | g01163206 |
2 wire sensor connector |
Caterpillar Information System:
TH48-E80 Oil/Gas Transmission Speed Sensor (Transmission) - Install
TH48-E80 Oil/Gas Transmission Speed Sensor (Transmission) - Remove
C15 Petroleum Generator Set Engines Turbocharger
TH48-E80 Oil/Gas Transmission Control Manifold - Assemble
TH48-E80 Oil/Gas Transmission Control Manifold - Disassemble
TH48-E80 Oil/Gas Transmission Control Manifold - Install
C15 Petroleum Generator Set Engines Fuel Filter Base
TH48-E80 Oil/Gas Transmission Control Manifold - Remove
C7 Engine for AP-1000D, AP-1055D, BG-2455D, and BG-260D Asphalt Pavers Engine Will Not Crank
3412 Generator Set Engines Fuel Injection Pump
3412 Generator Set Engines Fuel Injection Pump
3412 Generator Set Engines Fuel Injection Pump
TH48-E80 Oil/Gas Transmission Transfer Gears - Remove - Idler
TH48-E80 Oil/Gas Transmission Transfer Gears - Install - Idler
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Counterbalance Valve (Travel) - Install
TH48-E80 Oil/Gas Transmission Transfer Gears - Disassemble - Idler
TH48-E80 Oil/Gas Transmission Transfer Gears - Remove - Auxiliary
TH48-E80 Oil/Gas Transmission Transfer Gears - Install - Auxiliary
345C MHPU Mobile Hydraulic Power Unit Machine Systems Swing Drive - Remove
2005/08/01 New Serial Number Prefix {1000}
C-12 Generator Set Engine Event Codes
345C MHPU Mobile Hydraulic Power Unit Machine Systems Swing Drive - Install
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines CID 1785 FMI 10
C-12 Generator Set Engine Ether Injection System - Test