Aftercooler - Remove
Removal Procedure
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Drain the raw water system.
- Disconnect harness assemblies (1) and (2) .
Show/hide table
 | |
| Illustration 1 | g01183344 |
- Disconnect hoses (4) and (6) .
- Remove bolts (3) and disconnect the air shutoff from aftercooler (5) .
- Attach a suitable lifting device to aftercooler (5). The weight of aftercooler (5) is approximately 25 kg (55 lb). Remove bolts (7) and aftercooler (5) .
Show/hide table
 | |
| Illustration 2 | g01183357 |
- Remove gaskets (8) and plate (9) .
Caterpillar Information System:
3126B Petroleum Engine Camshaft - Install
Marine Multi-Station Control System PCP CID 1440 - FMI 03
Marine Multi-Station Control System PCP CID 1815 - FMI 12
Marine Multi-Station Control System PCP CID 1815 - FMI 13
Marine Multi-Station Control System PCP CID 1817 - FMI 09
2005/07/11 Improved Fuel/Water Separators are now Used {1260, 1261, 1263}
3126B Petroleum Engine Camshaft - Remove
Marine Multi-Station Control System PCP CID 1821 - FMI 09
Marine Multi-Station Control System Active Station - Test
Marine Multi-Station Control System Control Panel - Test
Marine Multi-Station Control System Data Link (Marine Power Display) - Test
Marine Multi-Station Control System Gear Lockout - Test
C7.1 Engines for Caterpillar Built Machines Boost Pressure Sensor
C7.1 Engines for Caterpillar Built Machines Coolant Temperature Sensor
C7.1 Engines for Caterpillar Built Machines Inlet Manifold Temperature Sensor
C6.6 Engines for Caterpillar Built Machines Electronic Control Module
C7.1 Engines for Caterpillar Built Machines Engine Oil Pressure Sensor
C7.1 Engines for Caterpillar Built Machines Inlet Manifold
Engine Valve Failure Modes{1100, 1105} Engine Valve Failure Modes{1100, 1105}
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines CID 0001 FMI 07
C15 and C18 Petroleum Generator Sets Overspeed
3126B Petroleum Engine Aftercooler - Install
C18 Petroleum Generator Sets Cooling System Coolant Level - Check
3126B Petroleum Engine Engine Oil Pan - Remove and Install