Aftercooler - Install
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install gaskets (8) and plate (9) on the engine.
Show/hide table
Illustration 1 | g01183357 |
Show/hide table
Illustration 2 | g01183403 |
- Attach a suitable lifting device to aftercooler (5). The weight of aftercooler (5) is approximately 25 kg (55 lb).
- Position aftercooler (5) on the engine and install bolts (7). Tighten the bolts in a numerical sequence to a torque of 31 ± 3 N·m (23 ± 2 lb ft).
- Connect the air shutoff to aftercooler (5) and install bolts (3) .
Show/hide table
Illustration 3 | g01183344 |
- Connect hoses (6) and (4) .
- Connect harness assemblies (2) and (1) .
- Refill the raw water system.
Caterpillar Information System:
C15 and C18 Petroleum Generator Sets Overspeed
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines CID 0001 FMI 07
Engine Valve Failure Modes{1100, 1105} Engine Valve Failure Modes{1100, 1105}
C7.1 Engines for Caterpillar Built Machines Inlet Manifold
C7.1 Engines for Caterpillar Built Machines Engine Oil Pressure Sensor
C6.6 Engines for Caterpillar Built Machines Electronic Control Module
C7.1 Engines for Caterpillar Built Machines Inlet Manifold Temperature Sensor
C7.1 Engines for Caterpillar Built Machines Coolant Temperature Sensor
C7.1 Engines for Caterpillar Built Machines Boost Pressure Sensor
3126B Petroleum Engine Aftercooler - Remove
3126B Petroleum Engine Camshaft - Install
Marine Multi-Station Control System PCP CID 1440 - FMI 03
C18 Petroleum Generator Sets Cooling System Coolant Level - Check
3126B Petroleum Engine Engine Oil Pan - Remove and Install
C7 On-highway Engine Air Inlet and Exhaust System
Marine Multi-Station Control System PCP CID 0718 - FMI 07
Marine Multi-Station Control System PCP CID 0700 - FMI 02
C18 Generator Sets Radiator - Clean
C13 and C15 On-highway Engines Diesel Particulate Filter Has Differential Pressure Problem
C15-XQ400 Rental Generator Set Engine Speed/Timing Sensors - Check/Clean/Calibrate
C7 and C9 On-Highway Engines Diesel Particulate Filter Temperature Is High
C13 and C15 On-highway Engines Diesel Particulate Filter Temperature Is Low
C7 and C9 On-Highway Engines Injector Solenoid - Test
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines CID 0002 FMI 02