Expansion Tank - Remove and Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
At operating temperature, the engine coolant is hot and under pressure. Steam can cause personal injury. Check the coolant level only after the engine has been stopped and the fill cap is cool enough to touch with your bare hand. Remove the fill cap slowly to relieve pressure. Cooling system conditioner contains alkali. Avoid contact with the skin and eyes to prevent personal injury. |
- Drain the coolant from the cooling system into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change".
Show/hide table
Illustration 1 g01166749 - Disconnect hose assembly (1) and hose (4) from expansion tank (2).
- Disconnect hose (5) from expansion tank (2).
- Remove bolts (3) and expansion tank (2).
- Place expansion tank (2) on the engine. Install bolts (3).
- Connect hose (5) to expansion tank (2).
- Connect hose (4) and hose assembly (1) to expansion tank (2).
- Refill the cooling system with coolant. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change".
Show/hide table
Illustration 2 | g01166749 |
Caterpillar Information System:
C27 and C32 Engines for Caterpillar Built Machines Injector Solenoid Circuit - Test
C4.4 Marine Generator Set Engines Idler Gear (Front) - Remove
C13 and C15 On-Highway Engines Engine Oil and Filter - Change
G3400 Engines (EIS) Programmable Parameters
C4.4 Marine Generator Set Engines Engine Oil Pan - Remove and Install
CX38-P892 Well Servicing Transmission General Hazard Information
C7 On-highway Engine Turbocharger
C13 and C15 On-Highway Engines Belts - Inspect/Adjust/Replace
3500B and 3500C Generator Set Engines Analog Sensor - Calibrate
3500B and 3500C Generator Set Engines Starting Motor System
C4.4 Marine Generator Set Engines Housing (Front) - Remove
C4.4 Marine Generator Set Engines Air Shutoff - Remove and Install
C4.4 Marine Generator Set Engines Idler Gear (Front) - Install
3500B and 3500C Generator Set Engines Diagnostic Codes
C9 Engine for Caterpillar Built Machines Fuel Priming Pump - Remove and Install
C4.4 Marine Generator Set Engines Speed/Timing Sensor - Remove and Install
C4.4 Marine Generator Set Engines Fuel Filter Base - Remove and Install
C4.4 Marine Generator Set Engines Electric Starting Motor - Remove and Install
C4.4 Marine Generator Set Engines Electric Starting Motor - Remove and Install
3500B and 3500C Generator Set Engines MID 036 - CID 0175 - FMI 04 Engine Oil Temperature short to ground
3500B and 3500C Generator Set Engines MID 036 - CID 0799 - FMI 12 Need Service tool update
3500B and 3500C Generator Set Engines MID 036 - CID 0175 - FMI 03 Engine Oil Temperature open/short to +batt
C7 On-highway Engine Cooling System
C9 Engine for Caterpillar Built Machines Fuel Filter Base - Remove and Install