Capacities (Refill)
Show/hide table
腔室或系统 | 升 | 美制加仑 | 英制加仑 |
变速箱和变矩器系统(保养加注) | 166.6 | 44 | 36.6 |
表 1 中所列的加注容量用于在例行维护时加注变速箱。 初次系统加注或系统维修后再加注需要使用额外的机油。 需要使用该机油来加注机油滤清器管路、机油滤清器、冷却器管路、冷却器和变矩器。 这部分额外的机油量将根据原始设备制造商冷却器管路所用的软管长度的不同而变化。 请参考操作和维护手册, "变矩器和变速箱机油油位 - 更换"中加注变速箱的正确程序。
Caterpillar Information System:
C27 and C32 Engines Cooling System - Test
3618 Engine Fuel System Primary Filter (Water Separator) Element - Replace
C27 and C32 Engines Cooling System - Check - Overheating
TH48-E80 Petroleum Transmission Lubricant Viscosities
C4.4 Marine Generator Set Engines Fuel Priming Pump and Fuel Filter Base - Remove and Install
G3400 Engines (EIS) Electrical Power Supply
C27 and C32 Engines Air Inlet and Exhaust System - Inspect
3618 Engine Refill Capacities and Recommendations
C9 Engines for Caterpillar Built Machines Fan Drive - Assemble
3606 and 3608 Engines Cylinder Block
G3400 Engines (EIS) Control Module Self Test
C9 Engines for Caterpillar Built Machines Fan Drive - Disassemble
C27 and C32 Industrial and Petroleum Engines Water Pump - Test
G3400 Engines (EIS) Propane Switch
G3400 Engines (EIS) Shutdown Lamp
TH48-E80 Petroleum Transmission Plate Locations and Film Locations
2005/04/11 Correction to Troubleshooting "Fuel Actuator" {1716}
Improving the Environment of the Operator{7301} Improving the Environment of the Operator{7301}
C15 and C18 Engines for Caterpillar Built Machines Alternator Mounting
C4.4 Marine Generator Set Sea Water Strainer - Clean/Inspect
2005/04/11 Tightness of Bolted Joints with the Torque Turn Procedure {1101, 1202, 1203, 1218}
C9 Engines for Caterpillar Built Machines Air Inlet Heater - Remove
3054C and C4.4 Industrial Engine and Marine Auxiliary Engine Gear Group (Front)
C6.6 Industrial Engine Safety Messages