Water Pump - Test
Show/hide table
Tools Needed | ||
Part Number | Part Name | Quantity |
6V-7775 | Air Pressure Gauge | 1 |
Show/hide table
Illustration 1 | g01157447 |
Show/hide table
Making contact with a running engine can cause burns from hot parts and can cause injury from rotating parts. When working on an engine that is running, avoid contact with hot parts and rotating parts. |
Perform the following procedure in order to determine if the water pump is operating correctly:
- Remove a plug from water manifold (1).
- Install the 6V-7775 Air Pressure Gauge in the port.
- Start the engine. Run the engine until the coolant is at operating temperature.
- Note the water pump pressure. The water pump pressure should be at least
100 kPa (15 psi) at rated speed.
Caterpillar Information System:
TH48-E80 Petroleum Transmission Capacities (Refill)
C27 and C32 Engines Cooling System - Test
3618 Engine Fuel System Primary Filter (Water Separator) Element - Replace
C27 and C32 Engines Cooling System - Check - Overheating
TH48-E80 Petroleum Transmission Lubricant Viscosities
C4.4 Marine Generator Set Engines Fuel Priming Pump and Fuel Filter Base - Remove and Install
G3400 Engines (EIS) Electrical Power Supply
C27 and C32 Engines Air Inlet and Exhaust System - Inspect
3618 Engine Refill Capacities and Recommendations
C9 Engines for Caterpillar Built Machines Fan Drive - Assemble
3606 and 3608 Engines Cylinder Block
G3400 Engines (EIS) Control Module Self Test
G3400 Engines (EIS) Propane Switch
G3400 Engines (EIS) Shutdown Lamp
TH48-E80 Petroleum Transmission Plate Locations and Film Locations
2005/04/11 Correction to Troubleshooting "Fuel Actuator" {1716}
Improving the Environment of the Operator{7301} Improving the Environment of the Operator{7301}
C15 and C18 Engines for Caterpillar Built Machines Alternator Mounting
C4.4 Marine Generator Set Sea Water Strainer - Clean/Inspect
2005/04/11 Tightness of Bolted Joints with the Torque Turn Procedure {1101, 1202, 1203, 1218}
C9 Engines for Caterpillar Built Machines Air Inlet Heater - Remove
3054C and C4.4 Industrial Engine and Marine Auxiliary Engine Gear Group (Front)
C6.6 Industrial Engine Safety Messages
C280-16 Petroleum Engine Prelube Pump Motors