 | |
| Illustration 1 | g00717858 |
(1) Torque for six bolts that hold the retainer to the housing ... 50 ± 7 N·m (37 ± 5 lb ft)
(2) Apply 9S-3263 Thread Lock Compound to the threads of eight bolts that hold the stator to the carrier. Torque for the bolts ... 40 ± 5 N·m (30 ± 4 lb ft)
(3) Torque for 36 bolts that hold the impeller to the housing ... 30 ± 5 N·m (22 ± 4 lb ft)
(4) Depth from the face of the carrier for installation of the seal ... 2.5 ± 0.5 mm (0.098 ± 0.020 inch)
(5) Lubricate the lip of the seal with SAE 30 oil.
(6) Torque for eight bolts that hold the carrier to the impeller ... 50 ± 7 N·m (37 ± 5 lb ft)
(7) Lubricate the bore lightly with clean oil for the power train.
(8) Torque for one bolt that holds the yoke to the shaft ... 115 ± 7 N·m (85 ± 5 lb ft)
(9) Outside diameter of the shaft at the bearing area ... 44.437 ± 0.013 mm (1.7495 ± 0.0005 inch)
- Inside diameter of the bearings after installation ... 44.501 ± 0.013 mm (1.7520 ± 0.0005 inch)
(10) Torque for eight bolts ... 50 ± 7 N·m (37 ± 5 lb ft)
(11) Inside diameter of the planetary gears ... 34.399 ± 0.008 mm (1.3543 ± 0.0003 inch)
(12) Diameter of the planetary shafts ... 26.439 ± 0.005 mm (1.0409 ± 0.0002 inch)
| Clearance Between the Components | Diameter Across the Components | Running (1) Clearance | |
|---|---|---|---|
| (A) Stator and Turbine |
new | 1.76 to 1.94 mm (0.070 to 0.077 inch) |
0.88 to 0.97 mm (0.035 to 0.039 inch) |
| 100% worn | 2.15 mm (0.085 inch) |
1.08 mm (0.043 inch) |
|
| (B) Stator and Impeller |
new | 1.17 to 1.32 mm (0.046 to 0.052 inch) |
0.59 to 0.66 mm (0.023 to 0.026 inch) |
| 100% worn | 1.54 mm (0.060 inch) |
0.77 mm (0.030 inch) |
|
| ( 1 ) | Half the clearance across the diameter |