Transmission Oil Level - Check
Check the transmission oil level while the machine is on a level surface.
The sight gauge for the transmission oil level is located on the left side of the machine under the steps.
Show/hide table
Illustration 1 | g00627269 |
- Maintain the transmission oil level between the "LOW" mark and the "HIGH" mark on the sight gauge when the transmission is warm and the engine is running. Maintain the transmission oil level to the top of the sight gauge when the transmission is cool and the engine is not running.
Note: Check the transmission oil level by using the dipstick if the sight gauge is blocked. You may need to take more than one reading in order to achieve a consistent reading on the dipstick. The oil level needs to be maintained in the crosshatched area of the dipstick. The oil fill cap is also the dipstick.
- Remove the transmission filler plug and add transmission oil, if necessary.
Show/hide table
Illustration 2 | g00627264 |
- Clean the filler plug and install the filler plug.
Caterpillar Information System:
545 Wheel Skidder Machine Systems Grapple Arch (Dual Function) - Remove and Install
515 and 525 Wheel SkiddersMachine Systems Control Valve (Winch) - Disassemble - C-500 Series Winch
3056 Engine for Caterpillar Built Machines Engine Design
924Gz Wheel Loader Transmission Oil Filter - Replace
615C Wheel Tractor-Scraper Wheel Tractor-Scraper Power Train Selector and Pressure Control Valve (Transmission)
613C Series II Wheel Tractor-Scraper Air System and Brakes Air Compressor
3064 and 3066 Engines for Caterpillar Built Machines Crankshaft Rear Seal - Remove
615C Wheel Tractor-Scraper Wheel Tractor-Scraper Power Train Final Drive
D6R Track-Type Tractor Towing the Machine
615C Wheel Tractor-Scraper Wheel Tractor-Scraper Power Train Differential Lock
613C Series II Wheel Tractor-Scraper Air System and Brakes Electronic Monitoring System (EMS)
3064 and 3066 Engines for Caterpillar Built Machines Crankshaft Rear Seal - Install
3064 and 3066 Engines for Caterpillar Built Machines Cylinder Head - Install
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Fuel Shutoff Solenoid
545 Wheel Skidder Engine Supplement Engine - Install
3064 and 3066 Engines for Caterpillar Built Machines Cylinder Head - Remove
924Gz Wheel Loader Transmission Oil Sample - Obtain
924Gz Wheel Loader V-Belts - Inspect/Adjust/Replace
D7R Series II Track-Type Tractor Fuel System - Prime
C27 PET GEN SET Electric Power Generation and C27 KNOCKDOWN K Petroleum Power Train Package Fuel Conservation Practices
545 Wheel Skidder Machine Systems Pilot Valve (Grapple) - Disassemble
D7R Series II Track-Type Tractor Hydraulic System Oil Level - Check
545 Wheel Skidder Machine Systems Pilot Valve (Grapple) - Assemble
924G Wheel Loader Walk-Around Inspection