Transmission Oil Filter - Replace
Show/hide table
 | |
| Illustration 1 | g00627316 |
- The transmission filter is located on the left side of the machine under the steps. Remove the transmission oil filter element with a strap type wrench.
- Clean the filter element mounting base. Remove any part of the filter element gasket that remains on the filter element mounting base.
- Apply a light coat of oil to the gasket of the new filter element.
- Install the new filter element by hand. When the gasket contacts the mounting base, tighten the filter element for an additional three quarters of a turn.
- Start the engine and apply the service brake. Slowly operate the transmission controls in order to circulate the transmission oil.
- Move the transmission control lever to NEUTRAL and engage the parking. Inspect the filter element for leaks.
- Maintain the transmission oil level between the "LOW" mark and the "HIGH" mark on the sight gauge when the transmission is warm and the engine is running. Maintain the transmission oil level to the top of the sight gauge when the transmission is cool and the engine is not running. Add transmission oil, if necessary.
Note: Check the transmission oil level by using the dipstick if the sight gauge is blocked. You may need to take more than one reading in order to achieve a consistent reading on the dipstick. The oil level needs to be maintained in the crosshatched area of the dipstick. The oil fill cap is also the dipstick.
Show/hide table
 | |
| Illustration 2 | g00627269 |
- Stop the engine.
Caterpillar Information System:
615C Wheel Tractor-Scraper Wheel Tractor-Scraper Power Train Selector and Pressure Control Valve (Transmission)
613C Series II Wheel Tractor-Scraper Air System and Brakes Air Compressor
3064 and 3066 Engines for Caterpillar Built Machines Crankshaft Rear Seal - Remove
615C Wheel Tractor-Scraper Wheel Tractor-Scraper Power Train Final Drive
D6R Track-Type Tractor Towing the Machine
615C Wheel Tractor-Scraper Wheel Tractor-Scraper Power Train Differential Lock
613C Series II Wheel Tractor-Scraper Air System and Brakes Electronic Monitoring System (EMS)
3064 and 3066 Engines for Caterpillar Built Machines Crankshaft Rear Seal - Install
3126B Engine for Caterpillar Built Machines Coolant Temperature Sensor
615C Wheel Tractor-Scraper Wheel Tractor-Scraper Power Train Transfer Gears (Output)
3176C and 3196 Engines for Caterpillar Built Machines Fuel Temperature Sensor - If Equipped
D9R Track-Type Tractor Product Identification Number, Serial Number and EU's CE Plate Locations
3056 Engine for Caterpillar Built Machines Engine Design
515 and 525 Wheel SkiddersMachine Systems Control Valve (Winch) - Disassemble - C-500 Series Winch
545 Wheel Skidder Machine Systems Grapple Arch (Dual Function) - Remove and Install
924Gz Wheel Loader Transmission Oil Level - Check
3064 and 3066 Engines for Caterpillar Built Machines Cylinder Head - Install
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Fuel Shutoff Solenoid
545 Wheel Skidder Engine Supplement Engine - Install
3064 and 3066 Engines for Caterpillar Built Machines Cylinder Head - Remove
924Gz Wheel Loader Transmission Oil Sample - Obtain
924Gz Wheel Loader V-Belts - Inspect/Adjust/Replace
D7R Series II Track-Type Tractor Fuel System - Prime
C27 PET GEN SET Electric Power Generation and C27 KNOCKDOWN K Petroleum Power Train Package Fuel Conservation Practices