Control Valve (Winch) - Disassemble - C-500 Series Winch
Start By:
- Remove the winch control valve. Refer to Disassembly and Assembly, "Control Valve (Winch) - Remove" for the machine that is being serviced.
Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
- Remove plug (2) and O-ring seal (3) from valve body (1).
Show/hide table
Illustration 2 g00601691 - Remove spring retainer (4) and O-ring seal (5) from valve body (1).
- Remove spool assembly (6) from valve body (1).
Show/hide table
Illustration 3 g00601740 - Remove bolt (7), washers (8), washer (9), spring (10), exterior tube (11), interior tube (12), and washer (13) from spool (6).
Show/hide table
Illustration 4 g00601744 - Remove lip seal (14) from valve body (1).
Show/hide table
Illustration 5 g00601752 - Remove relief valve (19), O-ring seal (17), and O-ring seal (18) from valve body (1).
- Remove nipple assemblies (20) and O-ring seals (15). Remove plug (21) and O-ring seal (16).
Show/hide table
Illustration 1 | g00601679 |
Caterpillar Information System:
3056 Engine for Caterpillar Built Machines Engine Design
924Gz Wheel Loader Transmission Oil Filter - Replace
615C Wheel Tractor-Scraper Wheel Tractor-Scraper Power Train Selector and Pressure Control Valve (Transmission)
613C Series II Wheel Tractor-Scraper Air System and Brakes Air Compressor
3064 and 3066 Engines for Caterpillar Built Machines Crankshaft Rear Seal - Remove
615C Wheel Tractor-Scraper Wheel Tractor-Scraper Power Train Final Drive
D6R Track-Type Tractor Towing the Machine
615C Wheel Tractor-Scraper Wheel Tractor-Scraper Power Train Differential Lock
613C Series II Wheel Tractor-Scraper Air System and Brakes Electronic Monitoring System (EMS)
3064 and 3066 Engines for Caterpillar Built Machines Crankshaft Rear Seal - Install
3126B Engine for Caterpillar Built Machines Coolant Temperature Sensor
615C Wheel Tractor-Scraper Wheel Tractor-Scraper Power Train Transfer Gears (Output)
545 Wheel Skidder Machine Systems Grapple Arch (Dual Function) - Remove and Install
924Gz Wheel Loader Transmission Oil Level - Check
3064 and 3066 Engines for Caterpillar Built Machines Cylinder Head - Install
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Fuel Shutoff Solenoid
545 Wheel Skidder Engine Supplement Engine - Install
3064 and 3066 Engines for Caterpillar Built Machines Cylinder Head - Remove
924Gz Wheel Loader Transmission Oil Sample - Obtain
924Gz Wheel Loader V-Belts - Inspect/Adjust/Replace
D7R Series II Track-Type Tractor Fuel System - Prime
C27 PET GEN SET Electric Power Generation and C27 KNOCKDOWN K Petroleum Power Train Package Fuel Conservation Practices
545 Wheel Skidder Machine Systems Pilot Valve (Grapple) - Disassemble
D7R Series II Track-Type Tractor Hydraulic System Oil Level - Check