Crankshaft Rear Seal - Install
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Clean the back of the cylinder block and the mating surface of the backplate.
- Install crankshaft rear seal (3) on the cylinder block.
Show/hide table
Illustration 1 | g00578148 |
- Put a bead of 4C-9612 Silicone Sealant around the bolt holes and the face of the cylinder block.
- Position backplate (2) on the rear of the engine.
Show/hide table
Illustration 2 | g00578100 |
- Install bolts (1) that fasten backplate (2) on the engine. Tighten the bolts to the following torque:
3003 Engine ... 50 N·m (37 lb ft)
3013, 3014 and 3024 Engines ... 15 N·m (11 lb ft)
End By: Install the flywheel housing. Refer to Disassembly and Assembly, "Flywheel Housing - Remove and Install".
Caterpillar Information System:
3406E On-Highway Engine Connecting Rod Bearings - Install
988G Wheel Loader Power Train NoSPIN Differential
938G Wheel Loader and IT38G Integrated Toolcarrier Belts - Inspect/Adjust/Replace
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Fuel Filter Base
3406E On-Highway Engine Connecting Rod Bearings - Remove
963C Track-Type Loader Power Train Equalizer Bar - Install
3408E and 3412E Engines for Caterpillar Built Machines Air in Fuel - Test
3034 Engine for Caterpillar Built Machines Crankshaft Front Seal - Install
3408E and 3412E Engines for Caterpillar Built Machines Turbocharger - Remove
3408E and 3412E Engines for Caterpillar Built Machines Pistons and Connecting Rods - Install
615C Series II Wheel Tractor-Scraper Transmission Neutral Lock Control
613C Series II Wheel Tractor-Scraper Elevator Control
994D Wheel Loader Engine Supplement Alternator - Remove and Install
615C Wheel Tractor-Scraper Wheel Tractor-Scraper Power Train Differential and Bevel Gear - Adjust
3408E and 3412E Engines for Caterpillar Built Machines Turbocharger - Install
3406E On-Highway Engine Crankshaft Main Bearings - Install
994D Wheel Loader Engine Supplement Engine Electronic Control Module - Remove and Install
994D Wheel Loader Engine Supplement Fuel Priming Pump - Remove and Install
963C Track-Type Loader Power Train Track Drive Motor - Install
D10R Track-Type Tractor Model Specific Coolant Information
3034 Engine for Caterpillar Built Machines Crankshaft Rear Seal - Remove
D8R Track-Type Tractor Air Conditioner In-Line Dryer - Inspect
994D Wheel Loader Engine Supplement Fuel Transfer Pump - Remove and Install
994D Wheel Loader Power Train Auxiliary Drive Shaft - Remove