Connecting Rod Bearings - Remove
Start By:
- Remove the engine oil pump. Refer to Disassembly and Assembly, "Engine Oil Pump - Remove".
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Turn the crankshaft until the connecting rod bearing caps are accessible.
- Check the connecting rod and the connecting rod bearing caps for identification and for the location.
- Remove bolts (1) and the connecting rod bearing cap from the connecting rod. Remove the lower half of the connecting rod bearing from the connecting rod bearing cap.
- Push the connecting rod away from the crankshaft. Remove the upper half of the connecting rod bearing from the connecting rod.
- Repeat Steps 1 through 4 for the removal of the remainder of the connecting rod bearings.
Show/hide table
| |
| Illustration 1 | g00506275 |
Caterpillar Information System:
963C Track-Type Loader Power Train Equalizer Bar - Install
3408E and 3412E Engines for Caterpillar Built Machines Air in Fuel - Test
3034 Engine for Caterpillar Built Machines Crankshaft Front Seal - Install
3408E and 3412E Engines for Caterpillar Built Machines Turbocharger - Remove
3408E and 3412E Engines for Caterpillar Built Machines Pistons and Connecting Rods - Install
615C Series II Wheel Tractor-Scraper Transmission Neutral Lock Control
613C Series II Wheel Tractor-Scraper Elevator Control
613C Series II Wheel Tractor-Scraper Ejector Control
613C Series II Wheel Tractor-Scraper Bowl Control
615C Series II Wheel Tractor-Scraper Transmission Control
963C Track-Type Loader Power Train Track Roller Frame - Install
D6R Series II Track-Type Tractor Hydraulic System Oil Cooler and Bypass Valve
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Fuel Filter Base
938G Wheel Loader and IT38G Integrated Toolcarrier Belts - Inspect/Adjust/Replace
988G Wheel Loader Power Train NoSPIN Differential
3406E On-Highway Engine Connecting Rod Bearings - Install
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Crankshaft Rear Seal - Install
994D Wheel Loader Engine Supplement Alternator - Remove and Install
615C Wheel Tractor-Scraper Wheel Tractor-Scraper Power Train Differential and Bevel Gear - Adjust
3408E and 3412E Engines for Caterpillar Built Machines Turbocharger - Install
3406E On-Highway Engine Crankshaft Main Bearings - Install
994D Wheel Loader Engine Supplement Engine Electronic Control Module - Remove and Install
994D Wheel Loader Engine Supplement Fuel Priming Pump - Remove and Install
963C Track-Type Loader Power Train Track Drive Motor - Install