Crankshaft Front Seal - Remove
Removal Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 1U-7600     | Slide Hammer Puller     | 1     |
Start By:
- Remove the vibration damper and the crankshaft pulley. Refer to Disassembly and Assembly, "Vibration Damper and Pulley - Remove and Install".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide", for tools and supplies suitable to collect and contain fluids in Caterpillar machines. Dispose of all fluids according to local regulations and mandates. |
- Drill three evenly spaced 3 mm (.12 inch) holes in crankshaft front seal (1) .
Show/hide table
Illustration 1 | g00529162 |
- Use Tool (A) and remove crankshaft front seal (1) .
Caterpillar Information System:
515 Wheel Skidder and 525 Wheel Skidder Cooling System Water Temperature Regulator - Replace
D9R Track-Type Tractor Normal Steering
980G Wheel Loader Power Train Differential and Bevel Gear - Install
D9R Track-Type Tractor Changing Direction and Gear
963B Track-Type Loader Hydraulic System Lift and Tilt Pilot Control Valve
963B Track-Type Loader Walk-Around Inspection
G3500B Engines Starting the Engine
963B Track-Type Loader Hydraulic System Hydraulic Tank and Filter
D9R Track-Type Tractor Machine Operation Information
623F Wheel Tractor-Scraper Machine Systems Brake Actuator - Assemble
623F Wheel Tractor-Scraper Machine Systems Brake Actuator - Disassemble
623F Wheel Tractor-Scraper Machine Systems Load Cylinder - Install
515 Wheel Skidder and 525 Wheel Skidder Engine Air Filter Primary Element - Clean/Replace
515 Wheel Skidder and 525 Wheel Skidder Engine Air Filter Secondary Element - Replace
3046 Engine For Caterpillar Built Machines Crankshaft Front Seal - Install
631E Series II and 637E Series II Wheel Tractor-Scrapers Auger Hydraulic System Auger Charging System - Test and Adjust
994D Wheel Loader Sound Information and Vibration Information
994D Air System Wheel Loader Air Compressor
D9R Track-Type Tractor Power Train Track - Disassemble
D9R Track-Type Tractor Power Train Track - Assemble
D9R Track-Type Tractor Power Train Sprocket Segment - Remove and Install
980G Wheel Loader Machine Systems Pilot Valve (Steering) - Remove
611 Wheel Tractor-Scraper Differential and Final Drive Breather - Clean
980G Wheel Loader Machine Systems Pilot Valve (Steering) - Install