Pistons and Connecting Rods - Remove
Show/hide table
Required Tools | |||
---|---|---|---|
Tool | Part Number | Part Description | Qty |
A | 9S-9082 | Engine Turning Tool | 1 |
Start By:
- Remove the cylinder head. Refer to Disassembly and Assembly, "Cylinder Head - Remove".
- Remove the engine oil pump. Refer to Disassembly and Assembly, "Engine Oil Pump - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove the carbon ridge from the top inside surface of the cylinder liner.
- Use Tooling (A) and turn the crankshaft until two pistons are at the bottom center.
Show/hide table
Illustration 1 g00568813 - Remove nuts (1) and the bearing caps. Push the connecting rods and pistons until the piston rings are out of the cylinder liners.
Note: Be careful not to damage the cylinder liners and/or the crankshaft journals during the removal of the pistons and the connecting rods.
Note: The connecting rods will have numbers on the side with the tab slot of the connecting rod. Numbers are also marked on the bearing caps. The piston and the connecting rod must be installed in the correctly numbered cylinder. Etch the cylinder number in the proper location on a connecting rod and bearing cap if a connecting rod and bearing cap is new.
- Remove the pistons and connecting rods from the cylinder liners.
Caterpillar Information System:
G3520B Industrial Engine MID 036 - CID 0102 - FMI 08 Boost Pressure Sensor noisy signal
G3520B Industrial Engine Low Power/Poor or No Response to Throttle
G3520B Industrial Engine Air/Fuel Ratio Control
3412E, C30 and C32 Marine Engines Cylinder Liner - Install
G3520B Industrial Engine Troubleshooting Data Sheet
G3408 and G3412 Engines Carburetor Control Linkage
2006/03/06 Insulation on Exhaust Components {1000}
G3520B Industrial Engine MID 036 - CID 0102 - FMI 03 Boost Pressure Sensor short to +batt
3516B Generator Set Engines with Dynamic Gas Blending Valve Lash - Adjust
3406E and 3456 Generator Set Engines Fuel System Pressure - Test
3512B, 3512C, and 3516B Generator Set Engines with Dynamic Gas Blending Valve Mechanism
C15 and C18 Industrial Engines Turbocharger - Install - Single Turbocharger
2004/08/01 A New Head Gasket is Now Available as Service Replacement {1124}
G3408 and G3412 Engines Carburetor Control Linkage
3412E, C30 and C32 Marine Engines Connecting Rod Bearings - Remove
Installation and Initial Start-Up Procedure For G3520B Industrial Engines{1000} Installation and Initial Start-Up Procedure For G3520B Industrial Engines{1000}
G3408 and G3412 Engines Carburetor Control Linkage
G3408 and G3412 Engines Carburetor Control Linkage
C15 and C18 Industrial Engines Turbocharger - Remove - Dual Turbocharger
C15 and C18 Industrial Engines Turbocharger - Install - Dual Turbocharger
C15 and C18 Industrial Engines Exhaust Elbow - Remove and Install
3176C and 3196 Engines for Caterpillar Built Machines Cylinder Liner
C11 and C13 Petroleum Engines Crankshaft Seals
C13, C15, and C18 Tier 4 Final Engines Connecting Rod