Carburetor Control Linkage
Show/hide table
Illustration 1 | g01411493 |
(1) Position of the governor actuator at shutoff
(2) Position of the governor actuator at full load
(A) Travel of the governor actuator ... 32.5 degrees
(B) Travel of the actuator's shaft ... 20 + 10 degrees
(3) Stud
- Torque ... 17 ± 5 N·m (13 ± 4 lb ft)
Show/hide table
Illustration 2 | g01411495 |
(4) Position of the carburetor lever at shutoff
(5) Position of the carburetor lever at full load
(C) Shutoff position of the carburetor ... 40 degrees
(D) Full load position of the carburetor ... 35 degrees
Caterpillar Information System:
G3408 and G3412 Engines Carburetor Control Linkage
Installation and Initial Start-Up Procedure For G3520B Industrial Engines{1000} Installation and Initial Start-Up Procedure For G3520B Industrial Engines{1000}
3412E, C30 and C32 Marine Engines Connecting Rod Bearings - Remove
G3408 and G3412 Engines Carburetor Control Linkage
2004/08/01 A New Head Gasket is Now Available as Service Replacement {1124}
3412E, C30 and C32 Marine Engines Pistons and Connecting Rods - Remove
G3520B Industrial Engine MID 036 - CID 0102 - FMI 08 Boost Pressure Sensor noisy signal
G3520B Industrial Engine Low Power/Poor or No Response to Throttle
G3520B Industrial Engine Air/Fuel Ratio Control
3412E, C30 and C32 Marine Engines Cylinder Liner - Install
G3520B Industrial Engine Troubleshooting Data Sheet
G3408 and G3412 Engines Carburetor Control Linkage
C15 and C18 Industrial Engines Turbocharger - Remove - Dual Turbocharger
C15 and C18 Industrial Engines Turbocharger - Install - Dual Turbocharger
C15 and C18 Industrial Engines Exhaust Elbow - Remove and Install
3176C and 3196 Engines for Caterpillar Built Machines Cylinder Liner
C11 and C13 Petroleum Engines Crankshaft Seals
C13, C15, and C18 Tier 4 Final Engines Connecting Rod
G3408C and G3412C Engines Cylinder Head
G3408C and G3412C Engines Cylinder Head
3406E and 3456 Generator Set Engines Fuel System
3408C and 3412C Marine Engines Alternator and Regulator
3412E, C30 and C32 Marine Engines Crankshaft - Remove
C7 Engines for Caterpillar Built Machines Electrical System