Crankshaft Seals
Show/hide table
Illustration 1 | g01332511 |
(1) Crankshaft seal group (3) Crankshaft |
Note: Install the front crankshaft seals and the rear crankshaft seals dry.
(2) O-ring seal ... Lightly lubricate the seal with the lubricant that is being sealed.
Show/hide table
Illustration 2 | g01331026 |
Note: Use the alternating sequence that is shown when tightening the front and rear seal bolts.
Caterpillar Information System:
3176C and 3196 Engines for Caterpillar Built Machines Cylinder Liner
C15 and C18 Industrial Engines Exhaust Elbow - Remove and Install
C15 and C18 Industrial Engines Turbocharger - Install - Dual Turbocharger
C15 and C18 Industrial Engines Turbocharger - Remove - Dual Turbocharger
G3408 and G3412 Engines Carburetor Control Linkage
G3408 and G3412 Engines Carburetor Control Linkage
Installation and Initial Start-Up Procedure For G3520B Industrial Engines{1000} Installation and Initial Start-Up Procedure For G3520B Industrial Engines{1000}
3412E, C30 and C32 Marine Engines Connecting Rod Bearings - Remove
G3408 and G3412 Engines Carburetor Control Linkage
2004/08/01 A New Head Gasket is Now Available as Service Replacement {1124}
3412E, C30 and C32 Marine Engines Pistons and Connecting Rods - Remove
G3520B Industrial Engine MID 036 - CID 0102 - FMI 08 Boost Pressure Sensor noisy signal
C13, C15, and C18 Tier 4 Final Engines Connecting Rod
G3408C and G3412C Engines Cylinder Head
G3408C and G3412C Engines Cylinder Head
3406E and 3456 Generator Set Engines Fuel System
3408C and 3412C Marine Engines Alternator and Regulator
3412E, C30 and C32 Marine Engines Crankshaft - Remove
C7 Engines for Caterpillar Built Machines Electrical System
3412E, C30 and C32 Marine Engines Crankshaft - Remove
325D and 329D Excavators Storage Box - If Equipped
3406E and 3456 Generator Set Engines Fuel System - Prime
3406E and 3456 Generator Set Engines Electric Starting System - Test
C15 Petroleum Generator Set Engines Exhaust Temperature - Test