Connecting Rod Bearings - Remove
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 9S-9082 | Engine Turning Tool | 1 |
Start By:
- Remove the engine oil pump. Refer to Disassembly and Assembly, "Engine Oil Pump - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Check the connecting rod and the connecting rod bearing caps for identification and the orientation on the crankshaft.
- Use Tooling (A) and turn the crankshaft until the connecting rod bearing caps are accessible.
Show/hide table
Illustration 1 g00786899 - Remove nuts (1). Remove connecting rod bearing cap (2) from the connecting rod. Remove the lower half of the connecting rod bearing from the connecting rod bearing cap.
- Push the connecting rod away from the crankshaft. Remove the upper half of the connecting rod bearing from the connecting rod.
Caterpillar Information System:
G3408 and G3412 Engines Carburetor Control Linkage
2004/08/01 A New Head Gasket is Now Available as Service Replacement {1124}
3412E, C30 and C32 Marine Engines Pistons and Connecting Rods - Remove
G3520B Industrial Engine MID 036 - CID 0102 - FMI 08 Boost Pressure Sensor noisy signal
G3520B Industrial Engine Low Power/Poor or No Response to Throttle
G3520B Industrial Engine Air/Fuel Ratio Control
3412E, C30 and C32 Marine Engines Cylinder Liner - Install
G3520B Industrial Engine Troubleshooting Data Sheet
G3408 and G3412 Engines Carburetor Control Linkage
2006/03/06 Insulation on Exhaust Components {1000}
G3520B Industrial Engine MID 036 - CID 0102 - FMI 03 Boost Pressure Sensor short to +batt
3516B Generator Set Engines with Dynamic Gas Blending Valve Lash - Adjust
Installation and Initial Start-Up Procedure For G3520B Industrial Engines{1000} Installation and Initial Start-Up Procedure For G3520B Industrial Engines{1000}
G3408 and G3412 Engines Carburetor Control Linkage
G3408 and G3412 Engines Carburetor Control Linkage
C15 and C18 Industrial Engines Turbocharger - Remove - Dual Turbocharger
C15 and C18 Industrial Engines Turbocharger - Install - Dual Turbocharger
C15 and C18 Industrial Engines Exhaust Elbow - Remove and Install
3176C and 3196 Engines for Caterpillar Built Machines Cylinder Liner
C11 and C13 Petroleum Engines Crankshaft Seals
C13, C15, and C18 Tier 4 Final Engines Connecting Rod
G3408C and G3412C Engines Cylinder Head
G3408C and G3412C Engines Cylinder Head
3406E and 3456 Generator Set Engines Fuel System