Flywheel - Remove
Show/hide table
所需工具 | |||
---|---|---|---|
工具 | 零件号 | 零件说明 | 数量 |
A | 138-7573 | 提升支架 | 2 |
B | - | 导向螺柱 5/8 - 18 x 8 in |
2 |
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 将工具 (A) 和适当的起吊设备安装在飞轮 (2) 上。 飞轮 (2) 的重量约为
44 kg (97 lb) 。 - 拆下两个螺栓 (1)。 安装工具 (B)。
- 拆下剩余的螺栓 (1)。 拆下飞轮 (2)。
Show/hide table
图 2 g01091705 - 使用锤子和冲头以将齿圈 (3) 从飞轮 (2) 上拆下。
Show/hide table
图 1 | g01091639 |
Caterpillar Information System:
C13, C15, and C18 Tier 4 Final Engines Electronic Unit Injector
C3.3 Industrial Engine Engine Air Cleaner Element (Single Element) - Inspect/Replace
C15 Petroleum Generator Set Engines Fuel Transfer Pump
XQ125 Generator Set Driven Equipment - Check
C15 and C18 Industrial Engines Flywheel Housing - Remove and Install
G3500 Engines Cooling System Coolant (NGEC) - Change
3500 Industrial Engines Auxiliary Water Pump
C7 Marine Engines Engine Sensors - Remove and Install
C7 Marine Engines Fuel Cooler - Remove and Install
C4.4 (Mech) Industrial Engine Battery or Battery Cable - Disconnect
C4.4 (Mech) Industrial Engine Battery - Replace
3126E Truck Engines Reference Material
C18 Generator set and C18 Marine Engines Flywheel - Install
G3500 Engines Starting the Engine
C15 and C18 Industrial Engines Camshaft - Install
C15 and C18 Industrial Engines Camshaft - Remove
C13, C15, and C18 Generator Set Engines Speed Control (Switch) - Test
G3500 Generator Sets Cooling System Coolant (NGEC) - Change
C15 and C18 Industrial Engines Alternator - Remove and Install
3500 and 3500B Engines Electrical System
3516B and 3516B High Displacement Engines for 994D and 994F Wheel Loaders Crankcase Pressure Sensor
3500B and 3500C Marine Engines Turbocharger Inlet Pressure Sensor
C15 and C18 Industrial Engines Electric Starting Motor - Remove and Install
G3612 and G3616 Engines Safety Messages