 | |
| Illustration 1 | g00712967 |
| Clearance Between the Components | Diameter Across the Components | Running (1) Clearance | |
|---|---|---|---|
| (A) Stator and Turbine |
New | 1.76 to 1.94 mm (0.069 to 0.076 inch) | 0.88 to 0.97 mm (0.035 to 0.038 inch) |
| 100% Worn | 2.15 mm (0.085 inch) |
1.07 mm (0.042 inch) |
|
| (B) Stator and Impeller |
New | 1.17 to 1.32 mm (0.046 to 0.052 inch) |
0.58 to 0.66 mm (0.023 ± 0.026 inch) |
| 100% Worn | 1.54 mm (0.061 inch) |
0.77 mm (0.030 inch) |
|
| ( 1 ) | Half the clearance across the diameter |
(1) Torque for six bolts that hold the retainer to the housing ... 50 ± 7 N·m (37 ± 5 lb ft)
(2) Apply 4C-4030 Thread Lock Compound or 9S-3263 Thread Lock Compound to the threads. Torque for eight bolts that hold the stator to the carrier ... 40 ± 5 N·m (30 ± 4 lb ft)
(3) Torque for 36 bolts that hold the impeller to the housing ... 30 ± 5 N·m (22 ± 4 lb ft)
(4) Torque for eight bolts that hold the carrier to the impeller ... 50 ± 7 N·m (37 ± 5 lb ft)
(5) Lubricate the lip of the seal with SAE 80 oil.
(6) Torque for one bolt that holds the yoke to the shaft ... 115 ± 5 N·m (85 ± 5 lb ft)
(7) Outside diameter of the shaft in area of the sleeve bearings in the flange ... 44.437 ± 0.013 mm (1.7495 ± 0.0005 inch)
- Inside diameter of the sleeve bearings after installation in the flange ... 44.501 ± 0.013 mm (1.7520 ± 0.0005 inch)
(8) Impeller
(9) Turbine wheel
(10) Stator
(11) Inside diameter of the planetary gears ... 34.399 ± 0.008 mm (1.3543 ± 0.0003 inch)
(12) Diameter of the planetary shafts ... 26.439 ± 0.005 mm (1.0409 ± 0.0002 inch)