Fuel Filter Base - Remove
Removal Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 185-3630     | Strap Wrench Assembly     | 1     |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Remove the pressure plug and drain the fuel into a suitable container for storage or disposal.
- Use Tooling (A) in order to remove fuel filter (5) .
Show/hide table
Illustration 1 | g01076693 |
- Remove fuel temperature sensor (1) .
- Disconnect hose assembly (2). Plug all openings immediately.
- Remove bolts (3) .
- Remove fuel filter base (4) and the O-ring seals.
Caterpillar Information System:
G3516B Engines MID 036 - CID 1446 - FMI 09 Unable to communicate with Fuel Metering Module
G3516B Engines MID 036 - CID 1446 - FMI 09 Unable to communicate with Fuel Metering Module
G3516B Engines MID 036 - CID 1446 - FMI 05 Fuel Metering Module open circuit
C-10 Petroleum Engine Fuel Priming Pump - Remove and Install
G3516B Engines MID 036 - CID 1446 - FMI 05 Fuel Metering Module open circuit
C15 Petroleum Generator Set Engines Pinion Clearance - Adjust
C15 On-highway Engine Cylinder Head Valves
C15 On-highway Engines Turbocharger - Install - High Pressure
C15 On-highway Engines Turbocharger - Remove - High Pressure
C15 On-highway Engines Turbocharger - Install - Low Pressure
C15 On-highway Engines Turbocharger - Remove - Low Pressure
3406E and 3456 Generator Set Engines Connecting Rod Bearings - Install
C-10 Petroleum Engine Fuel Filter Base - Install
C-10 Petroleum Engine Fuel Transfer Pump - Remove
C-10 Petroleum Engine Fuel Transfer Pump - Install
C-10 Petroleum Engine Electronic Unit Injector - Remove
C-10 Petroleum Engine Electronic Unit Injector - Install
C9 Marine Generator Set Engines Engine Valve Lash - Inspect/Adjust
C15 On-highway Engines Exhaust Manifold - Remove and Install
C-10 Petroleum Engine Fuel Manifold - Remove
C-10 Petroleum Engine Fuel Manifold - Install
C27 and C32 Engines for Caterpillar Built Machines CID 0094 FMI 03 Fuel Pressure open/short to +batt
C27 and C32 Engines for Caterpillar Built Machines CID 0094 FMI 04 Fuel Pressure short to ground
C27 and C32 Engines for Caterpillar Built Machines CID 0100 FMI 03 Engine Oil Pressure open/short to +batt