Air Inlet Heater - Remove
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | - | Guide Stud (M10 x 1.50 x 60 mm) |
2 |
B | - | Guide Stud (M8 x 1.25 x 90 mm) |
2 |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Disconnect harness assembly (1) from the air inlet heater switch.
- Remove hose (9) and tube assembly (8) from aftercooler (2).
- Remove bolts (7) and tube assembly (6) from the aftercooler.
- Remove adapter (5) from the aftercooler.
- Remove two bolts (3). Install Tooling (A) into the base assembly.
- Remove remaining bolts (3).
- Remove support (10).
- Remove cover (2).
- Attach a suitable lifting device to core assembly (4) at Location (X) and remove core assembly (4). The weight of core assembly (4) is approximately
36 kg (80 lb) . - Remove Tooling (A) from the base assembly.
- Remove the gasket from the cover.
- Remove the gasket from the base assembly.
Show/hide table
Illustration 2 g01109421 - Disconnect harness assembly (11) at the air inlet heater.
- Disconnect inlet air temperature sensor (12).
- Remove two bolts (13). Install Tooling (B) into the cylinder head.
- Remove remaining bolts (13) and bolts (15).
- Remove base assembly (14).
- Remove air inlet heater (16) from the cylinder head.
- Remove Tooling (B) from the cylinder head.
Show/hide table
Illustration 1 | g01046229 |
Caterpillar Information System:
3408E and 3412E Engines for Caterpillar Built Machines Injection Actuation Pressure Sensor
G3500 Engines Fumes Disposal System
C7 Marine Engine Fuel Filter Base
C15 and C18 Engines for Caterpillar Built Machines Housing (Front) - Install
C15 and C18 Engines for Caterpillar Built Machines Housing (Front) - Remove
G3500 Engines Crankcase Breather
2004/11/01 Improved Fan Drives are Used {1359}
C7 Marine Engine Flywheel Housing
G3500 Engines Engine Oil Level Regulator
C12 Marine Engines Engine Crankcase Breather - Clean
C12 Marine Engines Engine Air Cleaner Service Indicator - Inspect
2004/04/01 Digital Multimeter Group (Clamp on) Rated at 2000 Amps Available for Electric Power Generation Applications {0709, 0785}
C9 Marine Engines and C9 Marine Generator Sets Air Inlet Heater - Install
3126B Petroleum Engine Auxiliary Water Pump
C7 Marine Engine Fuel Pressure Sensor - If Equipped
2004/03/29 Thermocouple Assembly (Exhaust) Measures Engine Exhaust Temperatures {0701, 0776, 0781}
C7 Marine Engine Engine Oil Temperature Sensor
C7 Marine Engine Coolant Level Sensor - If Equipped
C32 Marine Engine Cooling System
C32 Marine Engine Exhaust Temperature - Test
C32 Marine Engines Aftercooler - Test
C32 Marine Engine Cooling System - Check - Overheating
C15 Petroleum Generator Set Engines Inlet Manifold Air Pressure Sensor
C32 Marine Engine Cooling System - Test