Electronic Unit Injector Sleeve - Install
Show/hide table
| Required Tools | |||
| Tool | Part Number | Description | Qty |
| E | 221-9777 | Sleeve Installer | 1 |
| F | 4C-5552 | Large Bore Brush | 1 |
| G | 4C-9506 | Retaining Compound | - |
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Use Tooling (F) to clean the bore for the electronic unit injector sleeve.
Show/hide table
Illustration 1 g01108541 - Install new O-ring seals (2) on the new electronic unit injector sleeve (1). Lubricate the O-ring seals with clean engine oil.
- Apply a thin coating of Tooling (G) around the outer circumference of electronic unit injector sleeve (1) at Area (X).
- Place electronic unit injector sleeve (1) on Tooling (E).
- Position the electronic unit injector sleeve in the cylinder head. Use a hammer and Tooling (E) to install the electronic unit injector sleeve in the cylinder head.
Note: Allow Tooling (G) to cure for two hours at
End By:
- Install the electronic unit injectors. Refer to Disassembly and Assembly, "Electronic Unit Injector - Install" .
Caterpillar Information System:
C9 Marine Engines and C9 Marine Generator Sets Electronic Unit Injector Sleeve - Remove
G3500 Engines Gear Group (Front) - Reverse Rotation
3408C, 3412C and 3412D High Performance Marine Engines Electronic Control System Components
2003/10/01 Proper Termination Techniques May Increase Digital Voltage Regulator (DVR) Reliability {4467}
2003/10/01 The Water Resistance of the Wiring Harness Has Improved {1408}
3408C, 3412C and 3412D High Performance Marine Engines General Information
3408C, 3412C and 3412D High Performance Marine Engines Engine Design
2003/10/20 An Improved Turbocharger is Used {1052}
C9 Marine Engines and C9 Marine Generator Sets Crankshaft Gear - Remove and Install
2003/10/01 Improved Alternator Drive Assemblies, Auxiliary Drive Pulley Groups and Accessory Drive Groups {1151, 1207, 1425}
C3.3 Industrial Engine Bearing Clearance - Check
2003/10/01 New Seals for the Front Housing {1151, 1207}
3408C, 3412C and 3412D High Performance Marine Engines Fuel System
2013/08/21 Recommendations for Gas Engine Spark Plugs {1550, 1555}
C18 Marine Engines Engine Oil and Filter - Change
C27 and C32 Engines for Caterpillar Built Machines Fuel Filter Differential Pressure Switch Circuit - Test
SPP101 Skid Mounted Pumper Safety Messages
SPP101 Skid Mounted Pumper Plate Locations and Film Locations
SPP101 Skid Mounted Pumper Reference Material
3600 Heavy Fuel Engines Refill Capacities and Recommendations
C11 and C13 Engines for Caterpillar Built Machines E390 Fuel Filter Restriction
C9 Marine Engines and C9 Marine Generator Sets Housing (Front) - Remove
C9 Marine Engines and C9 Marine Generator Sets Housing (Front) - Install
2003/10/01 Correct Lash Setting for the Fuel Injector {1290}