Rocker Shaft - Assemble
Show/hide table
Alat yang Diperlukan | |||
Alat | Nomor Suku Cadang | Keterangan Suku Cadang | Jml |
A | 1P-0510 | Group Penggerak | 1 |
- Gunakan Peralatan (A) untuk memasang bushing untuk rocker arm. Untuk dimensi bearing yang benar, rujuk ke Spesifikasi, "Rocker Arm Injektor Unit Elektronik" dan Spesifikasi, "Mekanisme Katup".
Show/hide table
Ilustrasi 1 g01015498 - Pemasangan penyangga (5), rocker arm (4), rocker arm (3), dan rocker arm (2) pada poros (6).
Catatan: Penyangga (5) memiliki lubang offset.
Catatan: Kencangkan mur pada rocker arm (4), rocker arm (3), dan rocker arm (2) dengan torsi pengencangan
6 ± 3 N·m (53 ± 27 lb in) . Torsi putaran bebas sekrup tidak boleh melampaui0.4 N·m (3.5 lb in) . - Pasang penyangga (1).
Diakhiri dengan:
- Pasang poros ayun. Rujuk ke Pembongkaran dan Perakitan, "Poros Ayun dan Pushrod - Pemasangan".
Caterpillar Information System:
C9 Urban Transit Bus Engine Electric Starting Motor
Cat Gas Engine Lubricant, Fuel, and Coolant Recommendations Hydrogen Sulfide Effects on Engine Maintenance Costs
C15 On-highway Engine Precooler
G3406 Engines Electric Starting Motor
3408C and 3412C Marine Engines Engine Design
3456 Generator Sets Bearing Temperature - Measure/Record
C11 and C13 Engines for Caterpillar Built Machines Rocker Shaft - Disassemble
3456 Generator Sets Insulation - Test
G3500 Generator Sets Ignition System Timing - Check/Adjust
Installation Instructions for the 240-0716 Tube Kit for the High Pressure Oil Line for the Hydraulic Electronic Unit Injector (HEUI) Pump{1307, 1714} Installation Instructions for the 240-0716 Tube Kit for the High Pressure Oil Line for the Hydraulic Electronic Unit Injector (HEUI) Pump{1307, 1714}
2003/09/01 There Is a New Maximum Temperature for 2W-8147 Gear {1204}
G3520C and G3520E Generator Set Engines Air/Fuel Ratio Control
Cat® Digital Voltage Regulator Troubleshooting
C9 Urban Transit Bus Engine Wastegate Solenoid
C11 and C13 On-Highway Engines Air Lines
G3406 Engines Piston and Rings
3126B Engine for Caterpillar Built Machines Gear Group (Front)
C11 and C13 Engines Engine Oil Cooler - Install
C3.3 Industrial Engine Connecting Rod Bearings - Install
C11 and C13 Engines for Caterpillar Built Machines Electronic Unit Injector Sleeve - Remove
C11 and C13 Engines for Caterpillar Built Machines Electronic Unit Injector Sleeve - Install
C11 and C13 Engines for Caterpillar Built Machines Inlet and Exhaust Valves - Remove and Install
C3.3 Industrial Engine Connecting Rod Bearings - Remove
3456 Generator Sets Reference Numbers