 | |
| Illustration 1 | g00286672 |
 | |
| Illustration 2 | g00286673 |
When the electric starting motor is viewed from the pinion end, the motor rotates in the following direction. ... Clockwise
No load conditions at 25°C (77°F)
- Speed ... 7643 ± 1683 rpm
- Current draw ... 76.5 ± 14.5 amp
- Voltage ... 23 V
- Current draw ... 76.5 ± 14.5 amp
(1) Three wires are the maximum between the nuts. Tighten the nut on the battery terminal to the following torque. ... 30.5 ± 3.5 N·m (21 ± 3 lb ft)
(2) Tighten the nut on the ground terminal to the following torque. ... 30.5 ± 3.5 N·m (21 ± 3 lb ft)
(3) Tighten the ground terminal on the solenoid to the following torque. ... 2.25 ± 0.25 N·m (20 ± 2 lb in)
(4) The switch terminal must be insulated with heat shrink tube. Tighten the nut on the switch terminal to the following torque. ... 2.25 ± 0.25 N·m (20 ± 2 lb in)
(5) Tighten the nut on the motor terminal to the following torque. ... 30.5 ± 3.5 N·m (21 ± 3 lb ft)
(6) Tighten the bolt on the motor frame terminal to the following torque. ... 8 ± 3 N·m (70 ± 27 lb in)
Solenoid
Current draw at 20 V and 25°C (77°F)
- Pull-in windings ... 57 Amp
- Hold-in windings ... 16 Amp
 | |
| Illustration 3 | g00362864 |
 | |
| Illustration 4 | g00367673 |
When the electric starting motor is viewed from the pinion end, the motor rotates in the following direction. ... Clockwise
No load conditions at 25°C (77°F)
- Speed ... 6950 ± 1650 rpm
- Current draw ... 115 ± 25 amp
- Voltage ... 23 V
- Current draw ... 115 ± 25 amp
(1) Tighten the nut on the ground terminal to the following torque. ... 30.5 ± 3.5 N·m (21 ± 3 lb ft)
(2) Three wires are the maximum between the nuts. Tighten the nut on the battery terminal to the following torque. ... 30.5 ± 3.5 N·m (21 ± 3 lb ft)
(3) Tighten the ground terminal on the solenoid to the following torque. ... 2.25 ± 0.25 N·m (20 ± 2 lb in)
(4) The switch terminal must be insulated with heat shrink tube. Tighten the nut on the switch terminal to the following torque. ... 2.25 ± 0.25 N·m (20 ± 2 lb in)
(5) Tighten the nut on the motor terminal to the following torque. ... 30.5 ± 3.5 N·m (21 ± 3 lb ft)
(6) Tighten the nut on the motor frame terminal to the following torque. ... 30.5 ± 3.5 N·m (21 ± 3 lb ft)
Solenoid
Current draw at 20 V and 25°C (77°F)
- Pull-in windings ... 49.3 ± 3.3 Amp
- Hold-in windings ... 6.8 Amp maximum