Precooler
Show/hide table
Illustration 1 | g01101329 |
Right side view (2) Precooler |
(1) The diverter valve will use either a 12V switch or a 24V switch. The voltage that is used depends on the electrical system of the engine. The diverter valve is normally open.
Show/hide table
Illustration 2 | g01640934 |
(3) Final installation torque for the locknut ...
(4) Final installation torque for the valve cartridge group ...
(5) Final installation torque for four hex socket screw ...
Show/hide table
Illustration 3 | g01538014 |
(6) Final installation torque for the O-ring plug ...
Caterpillar Information System:
G3406 Engines Electric Starting Motor
3408C and 3412C Marine Engines Engine Design
3456 Generator Sets Bearing Temperature - Measure/Record
C11 and C13 Engines for Caterpillar Built Machines Rocker Shaft - Disassemble
3456 Generator Sets Insulation - Test
G3500 Generator Sets Ignition System Timing - Check/Adjust
Installation Instructions for the 240-0716 Tube Kit for the High Pressure Oil Line for the Hydraulic Electronic Unit Injector (HEUI) Pump{1307, 1714} Installation Instructions for the 240-0716 Tube Kit for the High Pressure Oil Line for the Hydraulic Electronic Unit Injector (HEUI) Pump{1307, 1714}
2003/09/01 There Is a New Maximum Temperature for 2W-8147 Gear {1204}
G3520C and G3520E Generator Set Engines Air/Fuel Ratio Control
2003/09/01 There Is a New Maximum Temperature for 2W-8147 Gear {1204}
2003/10/01 Fuel Transfer System for Power Modules {1256}
2003/08/04 There Is a New Maximum Temperature for 2W-8147 Gear {1204}
Cat Gas Engine Lubricant, Fuel, and Coolant Recommendations Hydrogen Sulfide Effects on Engine Maintenance Costs
C9 Urban Transit Bus Engine Electric Starting Motor
C11 and C13 Engines for Caterpillar Built Machines Rocker Shaft - Assemble
Cat® Digital Voltage Regulator Troubleshooting
C9 Urban Transit Bus Engine Wastegate Solenoid
C11 and C13 On-Highway Engines Air Lines
G3406 Engines Piston and Rings
3126B Engine for Caterpillar Built Machines Gear Group (Front)
C11 and C13 Engines Engine Oil Cooler - Install
C3.3 Industrial Engine Connecting Rod Bearings - Install
C11 and C13 Engines for Caterpillar Built Machines Electronic Unit Injector Sleeve - Remove
C11 and C13 Engines for Caterpillar Built Machines Electronic Unit Injector Sleeve - Install