Fuel Transfer System for Power Modules {1256}
- Power Module:
- PM3412 (S/N: 5FL1-UP; CAJ1-UP)
- Engine:
- 3406C (S/N: 4ZR1-UP; 1LS1-UP)
- PM3508 (S/N: BLM1-UP)
- PM3512 (S/N: BRF1-UP; BNR1-UP)
- PM3516 (S/N: CAC1-UP; BPD1-UP)
- 3412 (S/N: 81Z1-14500)
- 3412C (S/N: 81Z14501-UP; BAK1-UP)
- 3508 (S/N: 23Z1-UP)
- 3508B (S/N: 6PN1-UP)
- 3512 (S/N: 24Z1-UP)
- 3512B (S/N: 8RM1-UP)
- 3516 (S/N: 5SJ1-UP; 25Z1-UP)
- 3516B (S/N: 7RN1-UP; 1NW1-UP)
A Special Instruction that describes the method for determining the correct fuel pressure to the fuel transfer system has been released. Refer to Special Instruction, REHS1751-03, "Pressure Requirements for the Fuel Transfer System" for Power Modules and Engines that are equipped with the following fuel transfer systems:
Caterpillar Information System:
2003/08/04 There Is a New Maximum Temperature for 2W-8147 Gear {1204}
G3406 Engines Engine Oil Pan
C11 and C13 Engines for Caterpillar Built Machines Inlet and Exhaust Valve Guides - Remove and Install
G3406 Engines Engine Oil Pan
Cat® Digital Voltage Regulator Wiring Diagrams
2004/04/01 New Rocker Arm Improves Lubrication {1123}
G3406 Engines Engine Oil Pan
C11 and C13 Engines for Caterpillar Built Machines Inlet and Exhaust Valve Seat Inserts - Remove and Install
Customer Interface for the 3512B Well Fracturing Engine (ADEM II){1408} Customer Interface for the 3512B Well Fracturing Engine (ADEM II){1408}
2003/09/01 Improved Pump Drive Gear for an Auxiliary Sea Water Pump {1242}
C11 and C13 Engines for Caterpillar Built Machines Front Cover - Install
C15 and C18 Engines for Caterpillar Built Machines Injector Solenoid Circuit - Test
2003/09/01 There Is a New Maximum Temperature for 2W-8147 Gear {1204}
G3520C and G3520E Generator Set Engines Air/Fuel Ratio Control
2003/09/01 There Is a New Maximum Temperature for 2W-8147 Gear {1204}
Installation Instructions for the 240-0716 Tube Kit for the High Pressure Oil Line for the Hydraulic Electronic Unit Injector (HEUI) Pump{1307, 1714} Installation Instructions for the 240-0716 Tube Kit for the High Pressure Oil Line for the Hydraulic Electronic Unit Injector (HEUI) Pump{1307, 1714}
G3500 Generator Sets Ignition System Timing - Check/Adjust
3456 Generator Sets Insulation - Test
C11 and C13 Engines for Caterpillar Built Machines Rocker Shaft - Disassemble
3456 Generator Sets Bearing Temperature - Measure/Record
3408C and 3412C Marine Engines Engine Design
G3406 Engines Electric Starting Motor
C15 On-highway Engine Precooler
Cat Gas Engine Lubricant, Fuel, and Coolant Recommendations Hydrogen Sulfide Effects on Engine Maintenance Costs