Heat Exchanger - Disassemble
Disassembly Procedure
Start By:
- Remove the heat exchanger. Refer to Disassembly and Assembly, "Heat Exchanger - Remove".
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
Show/hide table
 | |
| Illustration 1 | g00995159 |
- Remove bolts (8), cap (1), and O-ring seal (2). Remove plug (9) from cap (1) .
- Remove tubestack (3) from housing (4) .
- Remove bolts (7), cap (6), and O-ring seal (5) from housing (4) .
Caterpillar Information System:
G3520B Industrial Engine Ignition Transformers Secondary Circuit and Spark Plugs
C1.5 and C2.2 Marine Generator Set Engines Heat Exchanger - Remove
C1.5 and C2.2 Marine Generator Set Engines Heat Exchanger - Assemble
C1.5 and C2.2 Marine Generator Set Engines Auxiliary Water Pump - Install
3500B and 3500C Marine Propulsion Engines E279 High Aftercooler Temperature Warning
3406E and 3456 Generator Set Engines E173 High Exhaust Temperature Warning
C1.5 and C2.2 Marine Generator Set Engines Auxiliary Water Pump - Assemble
3500B and 3500C Marine Propulsion Engines E095 Fuel Filter Restriction Warning
C1.5 and C2.2 Marine Generator Set Engines Auxiliary Water Pump - Disassemble
C1.5 and C2.2 Marine Generator Set Engines Auxiliary Water Pump - Remove
3500B Series II Marine Engines E100 Low Engine Oil Pressure Warning
3500B Series II Marine Engines E040 Low Engine Oil Pressure Shutdown
C1.5 and C2.2 Generator Generator - Remove
C1.5 and C2.2 Marine Generator Set Engines Heat Exchanger - Install
C15 and C18 Petroleum Generator Sets Mounting and Dismounting
TK711, TK721, TK722 and TK732 Track Feller Bunchers Oil Filter - Inspect
3456 Generator Sets Voltage Regulators
G3500B Engines Junction Box
3054E Industrial Engine Fuel Injection Pump - Install
G3304 and G3306 Engines Auxiliary Water Pump - Assemble
3116 and 3126 Truck Engines Rocker Shaft and Pushrod - Remove
2003/05/01 New Cylinder Liner {1216}
2003/08/01 A Pin for the Rocker Shaft Is Now Available for Parts Service {1102}
3500B and 3500C Marine Propulsion Engines Electronic Display Module