0164-03 Injection Actuation Pressure voltage high (15)
产生此代码的情况:
发动机控制模块 (ECM) 检测到以下情况：
- 喷油驱动压力电路电压高于 4.8 VDC 超过 0.6 秒。
- 没有启动冷起动模式。
系统响应:
ECM 将指示并记录一个激活的代码。 检查发动机指示灯点亮。
ECM 将恢复到 10 MPa (1450.4 psi) 的缺省值。 卡特彼勒电子技师 (ET) 上"理想喷油驱动压力"和"实际喷油驱动压力"状态的旁边会显示 10 MPa (1450.4 psi)。
喷油驱动压力控制阀设定在 0.275 安培上。 喷油驱动压力控制阀的电流设定在固定位置上。 燃油输送受限。
注: 如果喷油驱动压力高于或低于额定充油压力的话，喷油驱动压力传感器就不会低于参考电压的 10% 或高于 90%。
ECM 会限定功率输出在89.5 kW (120.0 hp) 上，同时车速限定在 73 km/h (45 mph) 上。
由于没有启动冷起动模式，发动机起动阶段可能会冒白烟。
测试步骤 1. 进行以下的诊断步骤: 发动机压力传感器开路或短路 - 测试
结果:
- 正常 - 停止
Caterpillar Information System:
3512B Marine Auxiliary Engine Fuel in Cooling System
C7 and C9 On-Highway Engines 0164-02 Injection Actuation Pressure Signal Erratic (15)
3512B Marine Auxiliary Engine Factory Passwords Worksheet
C7 and C9 On-Highway Engines 0164-00 Excessive Injection Actuation Pressure (17)
G3612 and G3616 Engines Cylinder Head - Install
3512B Marine Auxiliary Engine Camshaft
3512B Marine Auxiliary Engine Customer Parameters Worksheet
3126B and 3126E On-highway Engines Programming Parameters
C-15, C-16, and C-18 Engines General Information
3512B Marine Auxiliary Engine Crankshaft
3512B Marine Auxiliary Engine Jacket Water Heater
G3520C and G3520E Generator Set Engines Compressor Bypass
C7 and C9 On-Highway Engines 0164-04 Injection Actuation Pressure voltage low (15)
C7 and C9 On-Highway Engines 0164-11 Injection Actuation Pressure system fault (39)
C7 On-highway Engine Reference Material
3406E, C-10 and C-12 On-highway Engines 0168-02 ECM Battery Power Intermittent (51)
3512B Marine Auxiliary Engine Too Much Vibration
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines 0022-11 Primary to Secondary Engine Speed Signal Calibration (42)
3126B and 3126E On-highway Engines 0022-13 Engine Speed Signal Calibration Not Performed (42)
G3520C and G3520E Generator Set Engines Electrical Connectors
C7 Urban Transit Bus Engines Electrical System
C7 Engines for Combat and Tactical Vehicles Safety Messages
C7 Urban Transit Bus Engines Model View Illustrations
3618 Engine Flywheel and Ring Gear - Remove and Install