0164-00 Excessive Injection Actuation Pressure (17)
产生此代码的情况:
发动机控制模块 (ECM) 检测到下述情况：
- 喷油驱动压力高于 30 MPa (4351 psi) 超过六秒。
- 发动机转速高于 0 MPH。
- 发动机冷却液温度高于 18°C (64 ° F)。
- ECM 至少已通电三秒钟。
- 没有启动冷起动模式。
注: 该故障诊断代码说明存在机械故障。 ECM 和电子控制系统正常工作。
系统响应:
状态屏上"喷油器输出 %"的旁边会显示 "0%"。
检查发动机指示灯点亮。
ECM 会限定功率输出在89.5 kW (120.0 hp) 上，同时车速限定在 73 km/h (45 mph) 上。
由于没有启动冷起动模式，发动机起动阶段可能会冒白烟。
注: 该故障只可能在正常工作温度下出现。
测试步骤 1. 进行以下的诊断步骤: 喷油驱动压力 - 测试
结果:
- 正常 - 停止
Caterpillar Information System:
G3612 and G3616 Engines Cylinder Head - Install
3512B Marine Auxiliary Engine Camshaft
3512B Marine Auxiliary Engine Customer Parameters Worksheet
3126B and 3126E On-highway Engines Programming Parameters
C-15, C-16, and C-18 Engines General Information
3512B Marine Auxiliary Engine Crankshaft
3512B Marine Auxiliary Engine Jacket Water Heater
G3520C and G3520E Generator Set Engines Compressor Bypass
3512B Marine Auxiliary Engine Cylinder Block, Liners and Heads
C7 Urban Transit Bus Engines Engine Description
G3520C and G3520E Generator Set Engines Aftercooler
3512B Marine Auxiliary Engines Flywheel Housing - Install
3512B Marine Auxiliary Engine Factory Passwords Worksheet
C7 and C9 On-Highway Engines 0164-02 Injection Actuation Pressure Signal Erratic (15)
3512B Marine Auxiliary Engine Fuel in Cooling System
C7 and C9 On-Highway Engines 0164-03 Injection Actuation Pressure voltage high (15)
C7 and C9 On-Highway Engines 0164-04 Injection Actuation Pressure voltage low (15)
C7 and C9 On-Highway Engines 0164-11 Injection Actuation Pressure system fault (39)
C7 On-highway Engine Reference Material
3406E, C-10 and C-12 On-highway Engines 0168-02 ECM Battery Power Intermittent (51)
3512B Marine Auxiliary Engine Too Much Vibration
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines 0022-11 Primary to Secondary Engine Speed Signal Calibration (42)
3126B and 3126E On-highway Engines 0022-13 Engine Speed Signal Calibration Not Performed (42)
G3520C and G3520E Generator Set Engines Electrical Connectors