Usage:
1-Brake lock linkage. 2-Bracket. Remove two bolts securing bracket to support.
3-Left steering clutch control linkage. 4-Right steering clutch control linkage. 5-Caps (six). 6-Right brake control linkage. 7-Left brake control linkage. 8-Control pedal assemblies.
This shows the pedals removed from the machine. The parts pointed out are: 9-Shims. Use as necessary to provide clearance between levers and pedals.
Control Pedals And Support Brace Unit Removal And Installation
1-Right brake control rod. 2-Left brake control rod. 3-Left brake pedal return spring. 4-Right brake pedal return spring. 5-Steering clutch control rods.
6-Tilt cylinder lines. 7-Center brake pedal return spring. 8-Parking brake lock ratchet. 9-Control pedals and support brace unit.
Steering Clutch Oil Filter Removal And Installation
1-Steering clutch oil filter.
Steering Clutch Oil Filter Disassembly
Steering Clutch Oil Screen
Steering Clutch Hydraulic Booster Removal
1. Remove steering booster cover.
2-Steering clutch hydraulic booster.
Steering Clutch Hydraulic Booster Disassembly
Oil Pump Removal And Installation
Viewed from rear. 1-Left steering clutch control rod. 2-Bolts (four). 3-Left steering clutch brake control rod. 4-Left steering clutch pedal. 5-Pump outlet oil line. 6-Pump inlet oil line. 7-Bolts (two). 8-Steering clutch oil pump.
Oil Pump Disassembly
3,7 Align bearing joints (at A and B) and install bearings .062 in. (1,57 mm) below the inner surfaces of the cover and base.
4 Pump drive gear must rotate freely by hand.
Steering Clutch Mechanical Components
1-Lever. Loosen bolt and remove key holding lever to shaft. 2-Lever and shaft. 3-Race. At assembly press onto shaft so top of race is 2.78 in. (70,6 mm) from upper end of shaft.
Steering Clutch Case Cover
1-Bearings. Not to project above bottom of counterbore.
Brake Engaging Mechanism
1-Cover. 2-Lever. 3-Key.
4-Bolt. Loosen and slide shaft through lever far enough to allow key to be removed from shaft. 5-Shaft. 6-Shaft assemblies. 7-Stop shaft. 8-Stop shaft.
If stop shafts are removed from steering clutch case cover, the setscrews which hold the shafts in position must be adjusted when installing the shafts. To do this, tighten the setscrews, then back off 11/2 turns and lock with lock wire.
