CIPI UNDERCARRIAGE Arrangements: 9Q-5195, 9Q-5197, 9Q-5198, 9Q-5232, 9Q-5504, 9Q-5643, 9Q-5651, 9Q-5727, 9Q-5728, 9Q-5729, 9Q-5730, 9Q-5731, 9Q-5747, 9Q-5876, 180-4029, and 213-3892 Caterpillar

Installation Procedure

Note: There is a track guide on each side of the machine. The procedure which follows is for the installation of the track roller with the track guide.

1. Make sure that all the mounting surfaces on the following components are clean and free of debris before the following components are installed:
   • Track Roller

   • Track Guide

   • Rock Guards

Show/hide table



Illustration 1	g00664675

Note: Make sure that the fill/drain plug in the track roller is facing toward the outside of the undercarriage.

2. Use Tooling (B) in order to put track roller (3) in position on the undercarriage.

   1. For Type "A" excavators, the weight of the track roller is approximately 34 kg (75 lb).

   2. For Type "B" excavators, the weight of the track roller is approximately 41 kg (90 lb).

3. Install the four bolts that hold the track roller in position.

Show/hide table



Illustration 2	g00664663

4. Use Tooling (B) in order to put track guide (2) in position on the undercarriage. Install the four bolts that secure the guide.

Show/hide table



Illustration 3	g00664665
(X) Rock guard

5. Install the rock guards, if equipped.

6. Prior to lowering the machine to the ground and tightening the track, make sure that all of the track rollers rotate smoothly by manually turning the track rollers.

Show/hide table



Illustration 4	g00489826

7. Lift the machine off Tooling (A) .

8. Remove Tooling (A) from the machine. Lower the machine to the floor.

9. Tighten the tension of the track. Refer to Operation and Maintenance Manual, "Track Adjustment - Adjust" for the correct procedure.