Electric Starting Motor
Show/hide table
| |
| 图 1 | g03334757 |
|
典型示例 | |
Show/hide table
| 技术规格 - 7C-0526 电起动马达总成和 7C-0527 电起动马达总成 | |||
| 项目 | 数量 | 零件 | 技术规格说明 |
| - | - | - | 当从小齿轮端观看电起动马达时，马达顺时针旋转。 |
| - | - | - | 20V 和 1. 对于拉动电流为 57 安培。 2. 对于保持电流为 16 安培。 |
| - | - | - | 在 最小转速为 7643 ± 1683 rpm。 最大电流消耗为 76.5 ± 14.5 Amp。 电压为 23 VDC。 |
| B | - | - | 加长小齿轮和壳体间的间隙为 |
| 1 | - | - | 蓄电池终端。 此螺母最多可使用三个电缆或导线接线端。 两个电缆接线端可以等于或高于 0 AWG。 |
| 拧紧螺母至扭矩为 |
|||
| 2 | - | - | 接地终端。 拧紧螺母至扭矩为 |
| 3 | - | - | 接地终端。 拧紧螺母至扭矩为 |
| 4 | - | - | 开关接线端。 拧紧螺母至扭矩为 开关端子必须用热收缩管绝缘。 不要使用模压端子。 |
| 5 | - | - | 马达终端。 拧紧螺母至扭矩为 |
| 6 | - | - | 马达机架终端。 拧紧螺母至扭矩为 |
Caterpillar Information System:
2002/01/01 Corrections to Operation and Maintenance Manual, SEBU6916-04, "3500B Engines and 3500 Engines With EUI Option" , "Maintenance Interval Schedule" {1000, 7500}
3176C and 3196 Engines For Caterpillar Built Machines Housing (Front) - Install
3408C and 3412C Marine Engines Electric Starting Motor
CIPI UNDERCARRIAGE Arrangements: 9Q-5262, 191-4041, and 204-9207 Travel Motor
3512B Engine for SPF343, SPS343, and SPT343 Pumpers Analog Sensor Supply
3054 and 3056 Marine Generator Set Engines Cylinder Head - Install - 3056 Engine
3054 and 3056 Marine Generator Set Engines Cylinder Head - Remove - 3056 Engine
CIPI UNDERCARRIAGE Arrangements: 9Q-5262, 191-4041, and 204-9207 Final Drives and Travel Motors
C0.5, C0.7, C1.1/3011C, C1.5/3013C, C1.6 and C2.2/3024C/3024CT Industrial Engines and Engines for Caterpillar Built Machines Fan - Remove and Install
C0.5, C0.7, C1.1/3011C, C1.5/3013C, C1.6 and C2.2/3024C/3024CT Industrial Engines and Engines for Caterpillar Built Machines Fan Drive
2002/02/01 A Cold Junction Compensator Is Now Available As A Service Replacement Part {7490}
CIPI UNDERCARRIAGE Arrangements: 9Q-5262, 191-4041, and 204-9207 Track Carrier Roller
Automatic Transfer Switches CTS, CTSD Series Network Card - Replace
Automatic Transfer Switches CTS, CTSD Series Network Card - Configure
CIPI UNDERCARRIAGE Arrangements: 9Q-5262, 191-4041, and 204-9207 Front Idler
Automatic Transfer Switches CTS, CTSD Series Network - Test
3512B Engine for SPF343, SPS343, and SPT343 Pumpers Digital Sensor Supply
2002/01/01 The Procedure For The Disassembly And Assembly Of The Gas Admission Valve Has Been Updated {1250}
3606, 3608, 3612 and 3616 Engines and C280-12, C280-16, C280-6 and C280-8 Marine Engines Standby Pump Panel General Information
CIPI UNDERCARRIAGE Arrangements: 9Q-5262, 191-4041, and 204-9207 Recoil Spring
3054 and 3056 Industrial and Generator Set Engines Water Pump
CIPI UNDERCARRIAGE Arrangements: 3Q6662, 6Z7861, 6Z7885, 6Z7947, 6Z7957, 6Z7999, 9Q5044, 9Q5065, 9Q5082, 9Q5090, 9Q5093, 9Q5115, 9Q5118, 9Q5126, 9Q5135, 9Q5141, 9Q5168, 9Q5175, 9Q5206, 9Q5255, 9Q5259, 9Q5268, 9Q5412, 9Q5436, 9Q5464, 9Q5514, 9Q5617, 9 Final Drive - Disassemble
CPT372 Truck Mounted Pumper Engine Oil Level - Check
3054 and 3056 Marine Generator Set Engines Heat Exchanger