CIPI UNDERCARRIAGE Arrangements: 9Q-5262, 191-4041, and 204-9207 Caterpillar

Type "A" Final Drive

Illustration 1	g00847418
(1) Oil drain plug (2) Oil level plug (3) Oil filler plug

1. Position one final drive so that oil drain plug (1) is at the bottom.

   Note: Refer to Operation and Maintenance Manual, "General Hazard Information" for information on Containing Fluid Spillage.

2. Remove oil level plug (2) .

3. Check the oil level. The oil should be near the bottom of the level plug opening.

4. Add oil through the opening of filler plug (3), if necessary.

   Note: Overfilling the final drive will cause the seals on the travel motor to allow hydraulic oil or water to enter the final drive. This may contaminate the final drive.

5. Clean oil level plug (2) and filler plug (3). Inspect the O-ring seal. Replace the O-ring seal if the O-ring seal is worn or damaged.

6. Apply pipe sealant to plugs (2) and (3) .

7. Install plugs (2) and (3) .

8. Repeat the procedure for the other final drive.

Type "B" Final Drive

Illustration 2	g00538194
(1) Oil drain plug (2) Oil level plug

1. Position one final drive so that oil drain plug (1) is at the bottom.

Note: Refer to Operation and Maintenance Manual, "General Hazard Information" for information on Containing Fluid Spillage.

2. Remove oil level plug (2) .

3. Check the oil level. The oil should be near the bottom of the level plug opening.

4. Add oil through the level plug opening, if necessary.

   Note: Overfilling the final drive will cause the seals on the travel motor to allow hydraulic oil or water to enter the final drive. This may contaminate the final drive.

5. Clean oil level plug (2). Inspect the O-ring seal. Replace the O-ring seal if the O-ring seal is worn or damaged.

6. Install oil level plug (2) .

7. Repeat the procedure for the other final drive.