415F2, 416F2, 420F2 IT, 420F2 ST, 430F2 IT and 430F2 ST Backhoe Loaders Power Train Caterpillar

Removal Procedure

Start By:

1. Remove the drive and steering axle.

2. Remove the final drive planetary.

Show/hide table

Illustration 1	g01047618

1. Loosen nut (2). Do not remove nut (2) at this time. Install Tooling (A). Remove tie rod end (1) and nut (2). Position tie rod end (1) out of the way.
   Show/hide table

   Illustration 2	g01047569

2. Remove bolts (5) and remove locking plate (4). Use Tooling (B) in order to remove spanner nut (3).
   Show/hide table

   Illustration 3	g01023074

   Show/hide table

   Illustration 4	g01023075

3. Use a suitable pry bar and push the double U-joint toward the wheel flange. This will enable the removal of retaining ring (8). Use Tooling (C) and remove retaining ring (8). Remove thrust washer (7) and washer (6).
   Show/hide table

   Illustration 5	g01023088

4. Remove ring gear (9).
   Show/hide table

   Illustration 6	g01023126

5. Remove wheel flange (10).

   Note: Bearing cone (11) will fall out of wheel flange (10) when wheel flange (10) is removed.

   Show/hide table

   Illustration 7	g01023130

   Note: Note the order and orientation of shims (14) for assembly purposes.

6. Remove bolts (12). Remove pin assembly (13) and shims (14). Remove bolts (16) and pin assembly (15).
   Show/hide table

   Illustration 8	g01023136

7. Use a suitable lifting device in order to remove knuckle (17). The weight of knuckle (17) is approximately 56 kg (123 lb).