Water Pump
Show/hide table
 | |
| Illustration 1 | g00785723 |
(1) Clearance between the impeller and the housing ... 0.75 ± 0.25 mm (.030 ± .010 inch)
(A) Seal
(2) Height of installed seal ... 12.19 mm (0.420 inch)
(3) Distance from the front of the water pump pulley to the face of the housing ... 151.8 ± 0.3 mm (5.40 ± 0.01 inch)
(4) The bearing must not extend beyond the edge of the housing.
(5) Water Pump Shaft
Note: Refer to Disassembly and Assembly for the complete procedure for installing the shaft and seal.
Caterpillar Information System:
G3516B and G3520B Generator Set Engines Heat Exchanger - Remove
3306B-XQ200 Rental Generator Set Engine Starting the Engine
795F and 795F Series AC Off-Highway Truck Power Train Final Drive, Brake and Wheel (Rear) - Assemble
3306B-XQ200 Rental Generator Set Engine Engine Oil and Filter - Change
2001/02/01 A New Service Is Available For 3600 Engine Fuel Injectors {1290, 1290}
XQ300, XQ400 Rental Generator Sets Trailer Identification
XQ300, XQ400 Rental Generator Sets Enclosure Identification
C-9 Industrial Engine Air Inlet Elbow
3406E Generator Set Engines Reference Numbers
3406E Generator Set Engines Generator Identification
3406E Generator Set Engines Engine Description
XQ300, XQ400 Rental Generator Sets Model View Illustrations
3126B and 3126E On-highway Engines 0190-00 Engine Overspeed Warning (35)
3126B and 3126E On-highway Engines 0105-11 Very High Intake Manifold Air Temperature (64)
3126B and 3126E On-highway Engines 0105-00 High Intake Manifold Air Temperature Warning (64)
G3516B and G3520B Generator Set Engines Heat Exchanger - Install
3406E Generator Set Engines Emergency Stopping
Electronic Installation Guide{1000} Electronic Installation Guide{1000}
XQ300, XQ400 Rental Generator Sets Setup
C-9 Industrial Engine Flywheel
XQ300, XQ400 Rental Generator Sets Before Towing
C-9 Industrial Engine Fan Drive
2001/02/01 A New Service Manual Module Is Available For The Marine Monitoring System II On 3600 Marine Engines {7490}
G3516B and G3520B Generator Set Engines Heat Exchanger - Disassemble