Fuel Transfer Pump - Remove
拆卸步骤
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
Show/hide table
注意 |
---|
在检验、保养、测试、调整及维修产品时,务必留心,确保液体盛装在容器中。 在打开任何腔室或拆解任何储有液体的部件之前,要准备好用合适的容器收集液体。 有关适合收集和盛接卡特彼勒产品上液体的工具及用品,参考专门出版物, NENG2500, "卡特彼勒工具和修理车间设备指南"。 按照当地法规和指令处置所有液体。 |
- 断开软管组件 (1) 和 (2) 。 塞上及盖上所有开口,以防止碎屑和污垢进入系统。
Show/hide table
图 1 | g00770238 |
- 拆下螺栓 (3) 和输油泵 (4) 。
- 检查输油泵 (4) 上 O 形密封圈 (5) 的状况。 如果 O 形密封圈磨损或损坏,则应使用新零件更换。
Show/hide table
图 2 | g00488105 |
Caterpillar Information System:
3524B Engines for 797 and 797B Off-Highway Trucks Flywheel - Inspect
795F and 795F Series AC Off-Highway Truck Power Train Final Drive, Brake and Wheel (Rear) - Disassemble
3406E and C15 Marine Engines Fuel Filter Base - Remove and Install
3406E Marine Engine Fuel Priming Pump - Remove and Install
3306B-XQ200 Rental Generator Set Engine Before Starting Engine
3406E Engine Turbocharger - Install
C-15 and C-16 Industrial Engines Air Compressor - Remove and Install
C-15 and C-16 Industrial Engines Crankshaft - Install
C-15 and C-16 Industrial Engines Engine Oil Pan - Remove and Install
3306B-XQ200 Rental Generator Set Engine Generator Identification
Air Compressor Installation Instructions{1803} Air Compressor Installation Instructions{1803}
SPP101 Skid Mounted Pumper S·O·S Oil Analysis
3406E Marine Engine Fuel Transfer Pump - Install
3406E and C15 Marine Engines Electronic Control Module - Remove and Install
2001/03/01 The Booklet, SENR9620, "Improving Fuel System Durability" Is Available {1250}
3126B and 3126E On-highway Engines Fast Idle Enable Circuit - Test
PM3500 Power Modules Parallel Operation
3406E Marine Engine Water Temperature Regulator - Remove and Install
PM3500 Power Modules Voltage Regulators
3126B and 3126E On-highway Engines Coolant Temperature Sensor - Remove and Install
C11 and C13 Engines for Caterpillar Built Machines Low Power/Poor or No Response to Throttle
3408E and 3412E Engines for Caterpillar Built Machines Poor Acceleration or Response
3406E Marine Engine Engine Oil Cooler - Remove
3126B and 3126E On-highway Engines Injection Actuation Pressure Sensor - Remove and Install