Flywheel - Inspect
Show/hide table
所需工具 | ||
---|---|---|
零件号 | 零件名称 | 数量 |
8T-5096 | 千分表总成 | 1 |
- 请参阅图 1 并安装千分表。 在读取千分表上的读数之前,在曲轴上施加一个同方向的力。 这样会消除曲轴端隙。
- 设定千分表以读取
0.0 mm (0.00 inch) 。 - 以 90 度为间隔转动曲轴,读取千分表的读数。
- 记录所有四个测点的测量值。 计算出较高和较低测量值之间的差值。 该数值就是跳动量。 飞轮的最大可允许表面跳动量(轴向偏心度)不得超过
0.15 mm (0.006 inch) 。
Show/hide table
图 1 | g00286049 |
检查飞轮的端面跳动 |
Show/hide table
图 2 | g01193057 |
检查飞轮的镗孔跳动 (1) 7H-1945 固定杆 (2) 7H-1645 固定杆 (3) 7H-1942 千分表 (4) 7H-1940 通用附件 |
- 安装 7H-1942 千分表 (3)。 调整 7H-1940 通用附件 (4),使千分表接触到飞轮。
- 设定千分表以读取
0.0 mm (0.00 inch) 。 - 以 90 度为间隔转动曲轴,读取千分表的读数。
- 记录所有四个测点的测量值。 计算出较高和较低测量值之间的差值。 该数值就是跳动量。 飞轮的最大可允许孔跳动量(径向偏心度)不得超过
0.15 mm (0.006 inch) 。Show/hide table图 3 g00286058 飞轮离合器导向轴承孔 - 记录所有四个测点的测量值。 计算出较高和较低测量值之间的差值。 该数值就是跳动量。 飞轮的最大可允许导向孔跳动量不得超过
0.13 mm (0.005 inch) 。
Caterpillar Information System:
795F and 795F Series AC Off-Highway Truck Power Train Final Drive, Brake and Wheel (Rear) - Disassemble
3406E and C15 Marine Engines Fuel Filter Base - Remove and Install
3406E Marine Engine Fuel Priming Pump - Remove and Install
3306B-XQ200 Rental Generator Set Engine Before Starting Engine
3406E Engine Turbocharger - Install
C-15 and C-16 Industrial Engines Air Compressor - Remove and Install
C-15 and C-16 Industrial Engines Crankshaft - Install
C-15 and C-16 Industrial Engines Engine Oil Pan - Remove and Install
3306B-XQ200 Rental Generator Set Engine Generator Identification
Air Compressor Installation Instructions{1803} Air Compressor Installation Instructions{1803}
SPP101 Skid Mounted Pumper S·O·S Oil Analysis
3516B Generator Set Engines with Dynamic Gas Blending Engine Oil Pressure - Test
3406E and C15 Marine Engines Fuel Transfer Pump - Remove
3406E Marine Engine Fuel Transfer Pump - Install
3406E and C15 Marine Engines Electronic Control Module - Remove and Install
2001/03/01 The Booklet, SENR9620, "Improving Fuel System Durability" Is Available {1250}
3126B and 3126E On-highway Engines Fast Idle Enable Circuit - Test
PM3500 Power Modules Parallel Operation
3406E Marine Engine Water Temperature Regulator - Remove and Install
PM3500 Power Modules Voltage Regulators
3126B and 3126E On-highway Engines Coolant Temperature Sensor - Remove and Install
C11 and C13 Engines for Caterpillar Built Machines Low Power/Poor or No Response to Throttle
3408E and 3412E Engines for Caterpillar Built Machines Poor Acceleration or Response
3406E Marine Engine Engine Oil Cooler - Remove